Photoshop PB gun milling contest winner

Thanks for those that had an entry in this contest.  I am choosing a winner a day early and without voting.

I'm basing my choice on several factors other than who has done what I consider to be the best drawing( sorry ExtremeBoost) with interest in the contest rating high in the factors. 

The winner of the patch is nforcr4.

I'll be doing a December contest with the prize being a partial LP kit for the Tippmann 98.  These parts were GIVEN to me by Artanis (thanks) and I'm going to extend the gift from Art to a forumer.

What Artanis gave me was the lp bolt with rear cocking knob and the dust cover.  The valve and low pressure chamber will have to be purchased from Tippmann.

I'll figure out what the contest will be later.

nforcr4 please pm me with your address and I'll get the patch to you. 

Thanks again for the entries

nm

Actually it would work if I owned a palmer i would just mill off the reg not the important part of the valve, and cap it with something. If you set a palmer at the same presure as the classic valve it would work and it so happens i own a palmer when i was gonna do the mill but it would cost to much, and i holoowed the reg in the back and did test it with the palmer soo i guess it does work doesn't it?

EDIT** The palmers gonna go on my cocker when i get it now you will see it, i don't lie I told the guy who owns Logic he said it does work allready did it but it wouldn't sell good because everyone would have to buy a palmer first and pay for the milling and the cap.

I have a 30-30 up at my camp though not in my room.....