Bravo One stuck on full auto

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Brought a Bravo One about 6 months ago and had no real problems with it until i went to do some routine maintenance on it . Well this is what happened, i opened it up to oil and for  some reason it just exploded and sent parts flying all round my kitchen.
After an hour or so searching for the lost parts i gave up the search and decided to sent for new parts from Tippmann.
Ok new parts arrived a few weeks later so i did no more and installed them as shown in manual, next i attached airtank and hopper and loaded it with paintballs. Off to my back garden i went .
I set E-Grip to single shot and pulled the trigger and to my surprise i got full auto fire but only 3 paintballs came out, i tried different setting on E-Grip but got the same response.

What am i doing wrong ??????

Any help would be GREAT. Thank you in advance.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Lurka Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 10 August 2010 Status: Offline Points: 2	Post Options Post Reply Quote Lurka Report Post Thanks(0) Quote Reply Topic: Bravo One stuck on full auto Posted: 20 August 2010 at 10:25am
	Brought a Bravo One about 6 months ago and had no real problems with it until i went to do some routine maintenance on it . Well this is what happened, i opened it up to oil and for some reason it just exploded and sent parts flying all round my kitchen. After an hour or so searching for the lost parts i gave up the search and decided to sent for new parts from Tippmann. Ok new parts arrived a few weeks later so i did no more and installed them as shown in manual, next i attached airtank and hopper and loaded it with paintballs. Off to my back garden i went . I set E-Grip to single shot and pulled the trigger and to my surprise i got full auto fire but only 3 paintballs came out, i tried different setting on E-Grip but got the same response. What am i doing wrong ?????? Any help would be GREAT. Thank you in advance.

oldpbnoob Members Profile Send Private Message Find Members Posts Add to Buddy List Platinum Member Not old, Not noob. May be Dave's grandma Joined: 04 February 2008 Location: Yankee Stadium Status: Offline Points: 5676	Post Options Post Reply Quote oldpbnoob Report Post Thanks(0) Quote Reply Posted: 20 August 2010 at 10:56am
	Is your tank full? A low tank can cause runaway. Are you certain you did not confuse the trigger spring and sear spring? Are you certain you have the correct sear in? The sear for the E-trigger is different. Do you have the correct sear pin in? It's black, not silver like the others.
	"When I grow up I want to marry a rich man and live in a condor next to the beach" -- My 7yr old daughter.

Lurka Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 10 August 2010 Status: Offline Points: 2	Post Options Post Reply Quote Lurka Report Post Thanks(0) Quote Reply Posted: 20 August 2010 at 11:13am
	yes tank was full @ the time, sear pin is black. think i`ve found the problem now thanks to your help. i ordered Sear Spring [Project Salvo] TA02036 should have ordered 02-88. sear is the original i only lost 2 springs and 2 of the receiver dowel pins. Wasn`t too sure which springs i losted so purchased 2 98-20 springs and the sear spring. which turned out that i never lost. Edited by Lurka - 20 August 2010 at 11:41am