![]() |
Bronco is...dead...pretty much... |
Post Reply ![]() |
Page 12> |
Author | |
[FI] ![]() Member ![]() Joined: 21 July 2004 Location: United States Status: Offline Points: 441 |
![]() ![]() ![]() ![]() ![]() Posted: 24 October 2004 at 6:24pm |
Okay, after closer examination and thought: Remember how it took awhile for my tranny to catch into drive. Yeah... The tranmission already takes 5 minutes to warm-up. When I put it in Reverse which works immediatly, the engine will slowly die out. It takes about five seconds or so. I can drop it into Neutral without a problem. When Drive won't catch and acts like Neutral, the engine is fine. Once Drive can catch, it dies unless I lay on the gas. If I'm on the break and stopped, it will die. This dieing takes a bit longer of a warm-up to end, maybe ten minutes. Any ideas? I'm probably going to replace the transmission, the shift column, and linkage soon. So, what I need to be looking at, from what people have been telling me, is: Drive Clutch Modulator Valve Torque Converter Transmission Sensor Burnt Clutch or Band Any idea why the engine stalls thought? Edited by [FI] |
|
Don't believe everything you think
I can resist anything but temptation |
|
![]() |
|
MetallicaESPa5 ![]() Platinum Member ![]() ![]() The Doors Of Perception Joined: 31 March 2004 Location: United States Status: Offline Points: 6331 |
![]() ![]() ![]() ![]() ![]() |
Just get a new car. You've had way to many problems with your bronco.
|
|
![]() |
|
![]() |
|
paintballman_13 ![]() Gold Member ![]() ![]() Joined: 16 March 2003 Location: Canada Status: Offline Points: 1790 |
![]() ![]() ![]() ![]() ![]() |
I second that. |
|
![]() |
|
[FI] ![]() Member ![]() Joined: 21 July 2004 Location: United States Status: Offline Points: 441 |
![]() ![]() ![]() ![]() ![]() |
I third that. Cool. $1500.00 |
|
Don't believe everything you think
I can resist anything but temptation |
|
![]() |
|
waarp8nt ![]() Member ![]() ![]() Joined: 28 August 2004 Location: United States Status: Offline Points: 170 |
![]() ![]() ![]() ![]() ![]() |
At this point your trans is beyond a sensor problem. I am not a Ford person, but on almost any Auto Trans, a failed/locked up Torque Converter can/will cause the vehicle to die or stall when put into gear. A burnt clutch could slip enough to allow the engine not to die off at times. Your trans needs replaced or overhauled, either way replace the Torque converter and have the cooler flushed (if you do not flush the cooler, your trans will overheat and fail again). or...........I 4th that you replace the beast. Edited by waarp8nt |
|
Tippmann 68 Carbine
D-feed X-core Palmer Direct Stabilizer Ricochet AK hopper J&J 12" barrel Y2K cradle/Drop Trigger Mods |
|
![]() |
|
BearClaw ![]() Moderator Group ![]() ![]() Joined: 19 August 2003 Location: Canada Status: Offline Points: 2102 |
![]() ![]() ![]() ![]() ![]() |
STOP DRIVING IT and fix it. Replace the trans then look inot the engin problem.
or sell it and get a new vehical Id sell you mine for the right price lol. |
|
AGD 68 Automag
Azodin KPII Sheridan PGP2K Tippmann Crossover XVR Tippmann ProCarbine Tippmann SL68-II Tippmann TiPX |
|
![]() |
|
Solipsism ![]() Member ![]() ![]() 300 million WHAT?! Joined: 11 February 2004 Location: Japan Status: Offline Points: 1850 |
![]() ![]() ![]() ![]() ![]() |
Like I said before, do a manual swap. An auto ina truck is rather lame if you ask me but whatever.
|
|
![]() |
|
[FI] ![]() Member ![]() Joined: 21 July 2004 Location: United States Status: Offline Points: 441 |
![]() ![]() ![]() ![]() ![]() |
Too expensive to change to manuel, although for this engine size, that's what it really needs. I'll get the transmission re-built, flush cooling stuff, and probably tune the carb. |
|
Don't believe everything you think
I can resist anything but temptation |
|
![]() |
|
[FI] ![]() Member ![]() Joined: 21 July 2004 Location: United States Status: Offline Points: 441 |
![]() ![]() ![]() ![]() ![]() |
Actually, replacing the parts is a lot cheaper since we can just get them and replace them (a friend of mine has rebuilt his entire truck). Drop out the tranny, have her re-built.... |
|
Don't believe everything you think
I can resist anything but temptation |
|
![]() |
|
evil_fingers ![]() Platinum Member ![]() ![]() Strike 1 - Inappropriate sig Joined: 27 March 2004 Location: Frisco Nor Cal Status: Offline Points: 7224 |
![]() ![]() ![]() ![]() ![]() |
Like I said before in yer other thread.....the problem you have is because you have a F.O.R.D.
|
|
Do not steal....the government hates competition!
![]() |
|
![]() |
|
Bunkered ![]() Platinum Member ![]() ![]() What AM I smoking? Joined: 10 June 2002 Location: United States Status: Offline Points: 5708 |
![]() ![]() ![]() ![]() ![]() |
Have you replaced the air filter and fuel filter? Or at least checked it?
Always check the easy things first, then move to the bigger, more expensice things... Like I said before, my car was stalling out and I replaced the air filter. Now it runs well again. |
|
![]() |
|
![]() |
|
BearClaw ![]() Moderator Group ![]() ![]() Joined: 19 August 2003 Location: Canada Status: Offline Points: 2102 |
![]() ![]() ![]() ![]() ![]() |
Hey Evil fingurs keep saying that as the FORD tow truck comes to tow you off the side of the road LOL.
I have my truck closeing in on 200k and (Knock on wood) it runs like a champ. I work on Chevys and Fords every day and the Fords plain out hold up better. Fords are ALOT beefier for proof take a look at the fron end setup of a GM 3500 with its 3/4" draglinks and tierods to the fords F350s 1 1/4". The Gm brakes look like they came off a honda civic while the fords look like they came off a semi. The GM runs a Single piston caliper for the front brake setup while the Fords run a Twin piston setup. The ford 7.3L Diesel engines hold from 10-17L of oil were as the Chevys WHIMPY 6.5L Diesel hold only 8L. Now if you say your a DODGE man i'll have a little more respect for ya but chebys just dont intrest me when it comes to trucks. Dodge has a GOOD engine (Diesel Cummins) and a decent truck (My buddy has one) but they are WAY TOO EXPENSIVE. |
|
AGD 68 Automag
Azodin KPII Sheridan PGP2K Tippmann Crossover XVR Tippmann ProCarbine Tippmann SL68-II Tippmann TiPX |
|
![]() |
|
Trogdor2 ![]() Platinum Member ![]() Joined: 05 June 2004 Location: United States Status: Offline Points: 5899 |
![]() ![]() ![]() ![]() ![]() |
Cars that don't work really suck...
|
|
Something unknown is doing we don't know what. That is what our knowledge amounts to. - Sir Arthur Eddington
|
|
![]() |
|
keithx ![]() Member ![]() ![]() Joined: 07 September 2004 Location: United States Status: Offline Points: 412 |
![]() ![]() ![]() ![]() ![]() |
my bronco is being born again hard...
If your engine is stalling with your foot on the brake like that... thats what happened to me... and it was the transmission modulator... it's like a $20 part and the installation is really easy... from what you PM'd me it sounds like you burnt a lot of the fluid... drain your pan... and while your at it do a gasket/filter... get as much of the old fluid out... drain the trans cooler lines running to the radiator... fill up with clean ATF... replace that modulator... see if that helps... |
|
I prefer .223 over .68
--------------------- A-5 R/T Flatline w/ F/X SD shroud F/X Sniper stock Intruder Assault Foregrip SpecterGear CQB 3pt Sling Crossfire 68/4500 (coming soon) |
|
![]() |
|
travis75 ![]() Gold Member ![]() ![]() Dear Penthouse.... Joined: 01 June 2004 Location: Great Britain Status: Offline Points: 1657 |
![]() ![]() ![]() ![]() ![]() |
get a toyota, like a mid 80's pickup with a 22R in it. They run forever |
|
Hey MPAA, Guess what?
09 f9 11 02 9d 74 e3 5b d8 41 56 c5 63 56 88 c0! |
|
![]() |
|
the_blade ![]() Platinum Member ![]() ![]() <esser is more Joined: 11 June 2002 Location: United States Status: Offline Points: 3219 |
![]() ![]() ![]() ![]() ![]() |
your timing chain or belt skipped a tooth so you motor has absolutly no torque behind it and thus dies off that would be my guess it could be a number of other things also.
|
|
95 base neon 3.0 cai, knifedged crankshaft 60 mill throttle body,14 crane cam crane springs/retainers eagle rods port matched/ polished intake p&p head shaved .015 phantom grip diff dohc exuast
|
|
![]() |
|
SandMan ![]() Platinum Member ![]() More like Rip Van Winkle AmIRite? Joined: 10 June 2002 Location: United States Status: Offline Points: 3907 |
![]() ![]() ![]() ![]() ![]() |
And preferably not one you have to Fix Or Repair Daily. |
|
Real Men Love Cheeses
|
|
![]() |
|
For Honor ![]() Gold Member ![]() ![]() 1 strike, stupid sexual slur Joined: 25 November 2003 Location: Neutral Zone Status: Offline Points: 1959 |
![]() ![]() ![]() ![]() ![]() |
solipsism, love the sig, but miss the storm trooper avatar
|
|
![]() |
|
![]() |
|
HondaXR ![]() Platinum Member ![]() ![]() Makes Foxworthy Look Like a Yankee Joined: 10 June 2002 Location: Alabama Status: Offline Points: 2740 |
![]() ![]() ![]() ![]() ![]() |
Hell yes get one of those suckers...Im looking for me a decent 4x4 'yota for a everyday driver and putting a lift and tires on my old CHEVY and turning it into a bogger. |
|
SL68II
Pro/Am 68 Carbine |
|
![]() |
|
evil_fingers ![]() Platinum Member ![]() ![]() Strike 1 - Inappropriate sig Joined: 27 March 2004 Location: Frisco Nor Cal Status: Offline Points: 7224 |
![]() ![]() ![]() ![]() ![]() |
Well, when my old 87 Dodge Caravan broke down I got lucky.....the tow truck was a Flatbed GMC truck from Triple A |
|
Do not steal....the government hates competition!
![]() |
|
![]() |
Post Reply ![]() |
Page 12> |
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |