JCS trigger stop

How can I make a trigger stop for the JCS Duel trigger? I noticed last night that it has A LOT of over travel. It's made of metal so I can't put a grub screw in the top of it. I don't want to put a q-tip in there inside the spring because it'll get smaller with every trigger pull; eventually becoming too small for any purpose at all. The only way I can think of is to put a grub screw in the trigger guard but I don''t think that'll look too hot.

Any ideas? Thanks.

I would do that if I had a 98. A-5's don't have a place to tap and put a set screw. They do have an rt hole but that's plastic and it's thin plastic in that area. Wait, not on the E-Grip. What am I thinking? And A-5's don't have two places for the trigger guard for what you're saying on the second idea. I actually did both of the things you suggested on my old 98 Custom. I did the LED mod also which was awesome. But that gun went away on eBay a couple of months ago. I loved that gun.

I'm looking for an internal trigger stop if possible. My last resort is the screw through the guard.

Counterfeit_Syn wrote: I was looking to do this same thing with my A5 but all I can think of is putting a screw or something in the trigger guard.

I think I might have to do that if no one else has any ideas. Did you end up putting it through the trigger guard?

I guess I can. Just drill a hole and tap it. I'll end up doing that or putting it through the guard.

JCS should have implemented one into the trigger some how.