My newly upgraded 98c

this is what i "rock":
Tippmann 98 custom
GTA double trigger
Dead-on RVA
GTA expansion chamber
20 oz co2
smart parts 14 inch progressive barrel
in yo face strip it screw kit
physco ballistics bullet drop
proto sticker (came with proto switch mask lol)
i just put the x-chamber on and i still need to install a gas line, so just pretend its there

is there any way to screw in 90 elbows for gaslines "easily"? the reason i dont have the gas line is that i was trying to turn it so hard that the metal bent in elbow hole where the gasline goes..its only a 2 dollar part so i dont care but i always find gaslines to be difficult

PaintbalSk8r14 wrote: You should get an electronic loader, then the ebolt and the low pressure kit and send it into tippmann to custom fit it.  Then it will be pimpin!  No offence but it couldnt hurt to put a better barrel on.

why whould he need to send it in to have it custom fit? its all drop in on the 98c

I would do screw a 90* elbow into each piece (drop, and xchamber) then attach a quick disconnect to the one on the drop, then run a steel line between them. If you are having trouble screwing them in, there is something wrong, put some teflon tape on the threads (also called plumbers tape, you can get it at any hardware store)

I would have invested in a slightly better barrel, if you want a cheap one, get a Bigshot, or a J&J Ceramic. But if you have the money, I would go with a Boomsick, or an Ultralite.

Get an electronic loader, if you want a cheap one, get an empire reloader, and if you have the money, look into a halo b or reloader b

Get some dye sticky 3 grips, they make a world of difference.

Do some custom milling ( model98.net ) or have someone do it for you ( nelsoncountycustoms.com ) Model98.net is currently down, but it should be back up soon.