|
remote |
Post Reply 
|
| Author | |
tippmanncp 
Member 
Joined: 25 September 2005 Status: Offline Points: 120 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: remotePosted: 31 October 2005 at 2:51pm |
|
ok my slide check on my remote has become dissconnected from the pin that allows co2 to enter the gun. so i was wondering if it would be safe to jb weld the pin to the slide check or not.
|
|
 |
|
|
tippmanncp
Member
Joined: 25 September 2005 Status: Offline Points: 120 |
Post Options
Thanks(0)
Quote Reply
Posted: 02 November 2005 at 3:41pm |
|
hey any body anwser this. i need to no
|
|
|
|
|
EriK6
Member
Joined: 11 June 2005 Location: United States Status: Offline Points: 457 |
Post Options
Thanks(0)
Quote Reply
Posted: 03 November 2005 at 8:30am |
|
Bring it to a pro shop and ask them what to do.
|
|
|
I can accept failure, but I can't accept not trying.
|
|
|
|
|
The Guy
Platinum Member 
Soup Can Guy Joined: 18 March 2004 Status: Offline Points: 6666 |
Post Options
Thanks(0)
Quote Reply
Posted: 03 November 2005 at 10:27am |
|
ok i think you lost me.
your slide check has become disconnected from your quick disconnect. Use teflon tape on the threads when you screw it in. JBweld would not be wise. If you snapped something off, do not jbweld it, its not strong enough to hold the pressure. |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options