E-bolt project

Not sure if you've seen the info on my e-bolt project, but I wanted to give you all the info and ask a few questions.

Currently I'm running an 98 Custom with a BSI ram, Tippman ASA/Reg, Timmy Noid, Rufus Dawg stick trigger, and I just had to put the BSI board back in (My Pred. board fried, it was used out of a friends gun, but it was freed at least).  The barrel i'll be using on it is my DYE Ultralite. 
I'm ordering my LPK sometime soon, I already have the funds, just shopping around a little.  And it will be fed by a z-board eggy.

I want to put a Rufus Dawg centerfeed on it.  How hard is this to do?  Is it a do it yourself job, or do I have to send it off to be installed. 

Next, What is the best LPR for the LPK?  I'm looking at a palmers fatty, but I wanted to make sure there wasn't something else out there I should be looking at.

That's what I was thinking.  Do any of you know of any other Stabilizers that would be comparable to this one, or better? 

pooperscooper wrote: The fatty isnt high enough pressure. Even for the LPK.

With the E-Bolt ram it is. Haven't I said it enough by now for you to see it around the forum: If you don't need the blow back to cock the hammer, you do not have to maintain 400 psi to operate the 98.

Failure to cock is the problem if you try to run too low pressures. There is no "cocking" required with a electro-pneumatically operated ram.

My 98C with the E-Bolt and LPK and the Hammerhead barrel (Nelson Hemorrhage paint) is giving me 275 fps at only 140 psi. Even with barrels that take a lot of gas, such as my Apex, I am still operating at on 240 psi...all well within the range of the Palmer Fatty.

Deadeye, there is nothing out there that is better than the Palmer...there is cheaper, yes...more expensive, yes...better, no!

deadeyevt wrote: wow, that's exactly what i needed to know...  awesome, that doesn't look too hard.  I'm sure i can get a whole like that drilled in no problem, just need a lot of lube!  Next question.  I got the Tippmann ASA/reg today (thanks Bruce), but how do you mount the thing?  It looks like a wearver mount...

Can't tell you the brand, but in looking through the drop forwards at a paintball store there were several that fit. There were also adapters that let it fit on any drop forward. It wasn't unique.

deadeyevt wrote: got ya, I found an Empire Nano rail that i believe will work.  Please correct me if i'm wrong.

It has been a while since I used that thing. As I think about it, there may be a part that came with it. Let me look a bit.

HOLD ON: I found the adapter that bolted the ASA to the bottom of the grip. This will allow the ASA to fit any drop forward that accepts a Tippmann ASA (standard or E-Bolt one). I'll drop it in the mail today. Sorry that I overlooked the part when I sent the ASA.