Helpful Mod For Trigger

If you want a shorter trigger pull than normal this will help. 

Note: This ONLY works with Double Trigger!!

Stuff you Need.

1.The stock trigger guard.

2. x-acto knife, Or dremel

3.Sand paper

4.Hammer and Small nail (smaller than half of a mm. in diameter or so)

Start

------------------------------------------------------------ -------

1. Use the knife or the Dremel to cut off the bottom part of guard. Then make it smooth with the sand paper. (Only the part that holds the guard onto the gun).

2.Hammer the nail into piece you just cut off that is faceing the outside.Hammer it into the piece as far as you think were it won't come out the back side.

3.Now again use the dremel to cut it until the trigger is able to shoot the gun.  Now for added reasurance cut it just a little bit more so that it is garunteed to fire. (Put it on the gun to get the measurments right)

4.Put it on the gun and test it a few times and Happy Killing. 

This should let you shoot faster. Cause the trigger won't go as far back and take longer to reset.

apollo

Dude i thought of this myself.

38 posts not bad 

apollo do you have a nail i could borrow i will give it back to you eventually oh ya and it has to be less than half a mm

o ya and did you notice im going to get an omen

lol.  I know.

zombieman was that a doubble no wait a tripple post, wait no quadruple post you will have 38 posts in no time

not cool