Please rate my 98c setup

Hey Everyone, I'm new to the forum so if somethings are done incorrectly, I apoligize. I just wanted to see if anyone would rate my setup?

1. 
   
   
2. 98custom w/ Response trigger
3. GTA expansion chamber
4. viewloader evolution 2 w/ y board (up to 17bps)
5. 12" Smartparts Progressive barrel
6. 32 degrees flame drop forward
7. 32 degrees BTB rear velocity adjuster
8. GTA double trigger

     I also have a 12" tippmann sniper barrel, but I hardly use it.

 Since I first posted this, I have also polished the internals, got an Adco IMP red dot sight, and I completely glass blasted the gun down to the bare aluminum. I'm in the process of painting it right now. Check out the post called Bare aluminum 98c if you want to see some pics of it glass blasted. Thanks.

 

Edited by Balls4U

It does its job. It gives the gun a different look, and makes adjustments much faster then screwing around with a allen wrench. For 9.99 I'd say it's worth it.

for your setup, probably a 6.5 outa 10, you stil need to upgrade to hpa, then reg, then low pressure, then e-bolt, many things to upgrade.

really nice gun man, all upgraded.

funny thing is, i have the same exact setup as you, only my gun dont got a expansion chamber

Edited by cockerkilla99

yeah i bet it gets the job done... but make it yours, give it a paintjob and such

stuf**edited** my bad

The x-chambers not on backwards, the bottom of it spins 360 degrees, and with the drop forward on, the hose that came with the kit wouldn't work. So i spun it around facing the other direction compared to how it would have normaly been, and used the stock hose to hook it up. It does (look) backwards, but it functions just the same.

7.5/10

8/10

nice setup reccommend flatline but otherwise 7/10

p.s. sniper barrels work great just don't go with anything over 14 inch unless you have the power to get the round throught a long barrel

Edited by Sniper21