RT prob

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I installed the rt and i put the gas in and pull the trigger and it does nothing.  I cant figure out the problem. plz help.thanks

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
austoo Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 09 March 2005 Location: United States Status: Offline Points: 5	Post Options Post Reply Quote austoo Report Post Thanks(0) Quote Reply Topic: RT prob Posted: 12 April 2005 at 7:35pm
	I installed the rt and i put the gas in and pull the trigger and it does nothing. I cant figure out the problem. plz help.thanks

Mack Members Profile Send Private Message Find Members Posts Add to Buddy List Moderator Group Has no impulse! control Joined: 13 January 2004 Location: 2nd Circle Status: Offline Points: 9906	Post Options Post Reply Quote Mack Report Post Thanks(0) Quote Reply Posted: 12 April 2005 at 10:59pm
	Have you tried adjusting the air flow on the rear fitting?


Kamakaze Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 12 April 2005 Status: Offline Points: 2	Post Options Post Reply Quote Kamakaze Report Post Thanks(0) Quote Reply Posted: 12 April 2005 at 11:45pm
	check your o-rings and that everything is tightened down but dont torque it too much
	"If guns kill people then i can blame mispelled words on my pencil" -Larry The Cable Guy

TrippiN Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 24 October 2003 Location: United States Status: Offline Points: 331	Post Options Post Reply Quote TrippiN Report Post Thanks(0) Quote Reply Posted: 13 April 2005 at 11:47am
	Well if you got a 98C when you tapped the hole on the rear right reciever.. did you try to make sure that there is nothing at all cming off the sides.. I mean like a jagged edge or something. My friend installed his and there was a small jagged edge where he tapped the hole out and it was created a gap between the air hose and rt inner connection hose... Make sure that they are completly touching.. there should be little or no play in the adjustment connector if you are moving it left to right or any direction. If that is not the problem.. Make sure that your co2 is full..make sure velocity isnt high. Now that that is checked, remove barrel, squirt about 2 small drops of oil into your tank adapter. Cock it back, put on co2, and fire like 10-15 times. This will oil up the interneals, and send some oil through that line, which could help to seal the connection.. If it still isnt working. Turn the RT adjustment screw all the way into the gun. Then while firing, on ever 2 shots, make a small turn out with the rt adjustment screw. This will eventually find the sweet spot, and get your rt the amount of air that it needs to run with. "sweet spot" would be a continuous strand of full auto.. Also, do not press tirgger super hard. Ive heard that too much force can stop the air from pushing out, and all it will do is reset the trigger back to its place without you letting it go.. which is pointless.. A light touch of the trigger, just enough to make it fire is good enough to set it off.. and..If the RT still isnt working.. only thing that i can suggest if take it to a pro shop or something near you to have them look at it. Hope this helps a little... Edited by TrippiN
	Spyder Imagine 2k4 --- -14" Custom barrel -DOP Xcore 8stage X Chamber -DOP Bullet Drop -12v Revvy w/x board ----

austoo Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 09 March 2005 Location: United States Status: Offline Points: 5	Post Options Post Reply Quote austoo Report Post Thanks(0) Quote Reply Posted: 13 April 2005 at 1:32pm
	Well i fixed it now and it fires but it fires just like semi auto. i adjusted the rate of fire and it doesnt do anything. shouldnt i just hold the trigger and it kkeeps firing?

TrippiN Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 24 October 2003 Location: United States Status: Offline Points: 331	Post Options Post Reply Quote TrippiN Report Post Thanks(0) Quote Reply Posted: 14 April 2005 at 12:30pm
	yes it should keep firing.. The thing is.. if it is firing semi auto.. then its not working.. so like i stated above, there has to be a leak. With any RT, there is no way for you to ajust the screw in and out, while firing and it does nothing unless there is a leak, or somethingis not properly sealed, or the number 1 cause, is not enough co2. Get the co2 refilled, and try it. It worked flawlessly with installing mine, and 2 friends of mine (when done right..) Also, take out the screw that connects to the outside right area of the power tube and mark it on each side where the hole is in it. (with a permanent sharpy or something..) and turn it in, when all the way in, without overtightening to break the power tube.. The lines should be aligned with the outter micro line which is connected with the air flow adjuster... I hope this helps a little more. Check the connections, velocity and air, hope you get it working like the rt should soon. and you still havent said if you got a A-5 or 98C
	Spyder Imagine 2k4 --- -14" Custom barrel -DOP Xcore 8stage X Chamber -DOP Bullet Drop -12v Revvy w/x board ----

JokerDooD Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 15 April 2005 Location: United Kingdom Status: Offline Points: 5	Post Options Post Reply Quote JokerDooD Report Post Thanks(0) Quote Reply Posted: 15 April 2005 at 7:41am
	well i have the RT in my a5 ,and everytime i take off the grip/trigger section and put it back on i break the seal from the trigger to the rest of the marker .its a little black o ring seal on the cylinder inside the grip .you should have a lok at this as all it takes is for a tiny little peice of that seal to be shaved off .try reinstaling the grip but this time loosen all screws in the grip so you dont have to force it on and be very carefull , worth a try .