|
low pressure kit question |
Post Reply 
|
| Author | |
blacklabel21 
Member 
Joined: 27 October 2005 Location: United States Status: Offline Points: 104 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: low pressure kit questionPosted: 31 December 2005 at 12:02pm |
|
Well i just got the lp kit for tippmann model 98 and the kit itself fits in there but when i put the other half of the gun on it doesnt want to fit on there it seems like it is to big for it and help would be nice thanks.
|
|
 |
|
|
cus98tom
Member
Joined: 12 July 2005 Status: Offline Points: 491 |
Post Options
Thanks(0)
Quote Reply
Posted: 31 December 2005 at 3:46pm |
|
Check the the "T" fitting that is screwed into the valve, you may need
to turn it in or out one turn, allso tighten the two valve bolts ( be
carefull not to overtighten , hold onto the short end of the allen
wrench) and then check that the vertical adapter is seated properly if
it is loosen the two valve bolts , tighen them when you do get it
together . I had to shave a few thousands off the "T" to
fit properly. Don't get frustrated and try to muscle it , bad thigs
uasually happen. If none of this works start installing one piece at a
time to see what is hanging up. ie. just the power tube and valve, just
the vertical adapter this will give a clearer view for your next course
of action.
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options