Tippmann Paintball Homepage
Forum Home Forum Home > Paintball Equipment > Gun Maintenace and Repair
  New Posts New Posts
  FAQ FAQ  Forum Search   Register Register  Login Login

BT-16 M98 Barrel kit
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Paintballer002 View Drop Down
Member
Member


Joined: 15 January 2006
Location: United States
Status: Offline
Points: 2 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Paintballer002 Quote  Post ReplyReply Direct Link To This Post Topic: BT-16 M98 Barrel kit
    Posted: 15 January 2006 at 9:23pm
I just got my BT-16 M98  Barrel kit and played a few games with it, and then the plastic part over the barrel got loose and came off and so did everything else on the barrel. Is there any way to fix this, or is this barrel garbage.
Back to Top
Mack View Drop Down
Moderator Group
Moderator Group
Avatar
Has no impulse! control

Joined: 13 January 2004
Location: 2nd Circle
Status: Offline
Points: 9906 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Mack Quote  Post ReplyReply Direct Link To This Post Posted: 15 January 2006 at 9:27pm
If your talking about the handguard that's attached to the barrel, it's probably held in place with an allen screw.  All you should need to do is realign all the parts and tighten the screw with an allen wrench.
Back to Top
Paintballer002 View Drop Down
Member
Member


Joined: 15 January 2006
Location: United States
Status: Offline
Points: 2 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Paintballer002 Quote  Post ReplyReply Direct Link To This Post Posted: 15 January 2006 at 9:33pm

I dont see any place for any kind of screws.

 
Back to Top
evil_fingers View Drop Down
Platinum Member
Platinum Member
Avatar
Strike 1 - Inappropriate sig

Joined: 27 March 2004
Location: Frisco Nor Cal
Status: Offline
Points: 7224 		Post Options Post Options   Thanks (0) Thanks(0)   Quote evil_fingers Quote  Post ReplyReply Direct Link To This Post Posted: 17 January 2006 at 1:39am
Ahhhhh, the infamous POS BT16 barrel Kit, its really a simple fix....between the Sling Swivel and the Front Sight, there is a very small Allen Head Screw, get the appropriate size hex wrench but, before you tighten the screw, realign all the Handguard parts together and then tighten the small screw....and like I stated in another thread, dump that POS of a Handguard and get a Rap4.com Phantom Handguard, its solidly built because, its made out of Aluminum and also comes wit Weaver/Picatinny Rails.
Do not steal....the government hates competition!
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.04
Copyright ©2001-2021 Web Wiz Ltd.

This page was generated in 0.500 seconds.