![]() |
A5 cyclone not feeding |
Post Reply
|
| Author | |
kristoff00
Member
Joined: 14 December 2009 Status: Offline Points: 31 |
Post Options
Thanks(0)
Quote Reply
Topic: A5 cyclone not feedingPosted: 10 May 2010 at 1:56am |
|
I recently bought a qev for my cyclone feed however I have not bought my egrip yet so im just trying to use it for the mechanical setup, however it wont feed. At first it did then I thought I was jamming up because it was only shooting every other shot (got me shot down btw) then it turned to like 1 for every 5 shots, then nothing the paddles dont spin.
what is wrong |
|
![]() |
|
Motown Moron
Member
Joined: 10 May 2010 Location: Spartnaburg, SC Status: Offline Points: 3 |
Post Options
Thanks(0)
Quote Reply
Posted: 10 May 2010 at 4:52pm |
|
Hey Kris, Any audible signs off air leaking when you pull the trigger? If not, disassemble and clean+lubricate the entire cyclone feed. Check the Cylinder plug, spring and piston for a fail point. Don't over-tighten any of the screws holding it together.
-Motown Moron
|
|
![]() |
|
kristoff00
Member
Joined: 14 December 2009 Status: Offline Points: 31 |
Post Options
Thanks(0)
Quote Reply
Posted: 10 May 2010 at 5:04pm |
|
well actually that day something was wrong with my reg on my bottle, I think the burst disk was leaking, but only when I screwed it into a gun, but nothing out of the gun
|
|
![]() |
|
Post Reply
|
|
|
Tweet
|
| Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |