Polishing your internals

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic


   you are not polishing any parts just inside the receivers were the parts go just take the gun apart and look at the inside of the receivers and you will see all of the black paint that over sprayed and thats what you get off

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
the a-5 RIPPER Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 29 December 2004 Status: Offline Points: 81	Post Options Post Reply Quote the a-5 RIPPER Report Post Thanks(0) Quote Reply Posted: 02 March 2005 at 10:49am
	you are not polishing any parts just inside the receivers were the parts go just take the gun apart and look at the inside of the receivers and you will see all of the black paint that over sprayed and thats what you get off

Tipp-ity Tom Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 30 January 2005 Location: United States Status: Offline Points: 74	Post Options Post Reply Quote Tipp-ity Tom Report Post Thanks(0) Quote Reply Posted: 02 March 2005 at 11:35am
	ok. i gotcha. thanks for your help.
	Tippmann A-5 Flatline Barrel & PT Shroud 12" Lapco Bigshot & Machine Gun Shroud E-grip & JCS Double Trigger JCS Voodoo Stock w/ RVA Lapco Milsim Foregrip 32 Degrees Remote Crossfire 68/4500

Curlyman666 Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 05 January 2005 Location: Antarctica Status: Offline Points: 357	Post Options Post Reply Quote Curlyman666 Report Post Thanks(0) Quote Reply Posted: 02 March 2005 at 11:48am
	ok this is exactly what you do,step by step,for a m98 or 98c remove tank unscrew ASA remove barrel unscrew receiver screws remove left half of receiver remove all parts unscrew valve screws on right side of marker(careful they strip easy) remove valve(power tube) wipe off any oil or grease or w/e else is in there rinse off receiver halves with water dry take piece of steel wool roll it up into a ball about the size of a paintball rub against the receiver where the rear bolt slides until there is no more black,it should be pretty shiny then do where the power tube slides,the same way next,polish the trigger area in the same way do the same to the other receiver half now get a piece of steel woll about the size of your small finger nail polish the area where the rod that connects the front and rear bolt slides do the same for the other half wash the halves again dry them re-lubricate put the valve back in and screw the valve screws in put all parts back in,re-lubricate them if necessary put the receiver half back on screw in the receiver screws i hope this doesnt sound too complicated,it really isnt hi i wanted 30 steps cuz it sounds better than 28
	signature

the a-5 RIPPER Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 29 December 2004 Status: Offline Points: 81	Post Options Post Reply Quote the a-5 RIPPER Report Post Thanks(0) Quote Reply Posted: 02 March 2005 at 2:44pm
	no problem before i did it i was lost to

nforcer4 Members Profile Send Private Message Find Members Posts Add to Buddy List Gold Member BANNED Joined: 10 April 2004 Location: Canada Status: Offline Points: 1269	Post Options Post Reply Quote nforcer4 Report Post Thanks(0) Quote Reply Posted: 02 March 2005 at 3:16pm
	Just steel wool was used for that^^