Tippmann Paintball Homepage
Forum Home Forum Home > Paintball Equipment > Gun Maintenace and Repair
  New Posts New Posts
  FAQ FAQ  Forum Search   Register Register  Login Login

A5 + LPK
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Throesch View Drop Down
Member
Member


Joined: 23 April 2005
Status: Offline
Points: 1 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Throesch Quote  Post ReplyReply Direct Link To This Post Topic: A5 + LPK
    Posted: 29 May 2005 at 4:23am
ok i installed the lpk into my a5 got it working go me i think. i alos have the palamer fatty installed on it and the e-grip. well here is the problem i ran into when i first got the lpk installed and loaded co2 to it (HPA tank not in yet) all went well i cocked it and fired well then the gun just went off the wall i had to manualy recock it or it woulnd push the power tube back all the way to the trigger. well after many times of cutting the spring it would go back to the trigger like its supposed to. well now when i first load co2 to the gun cock it and fire it slipps i then recock it and its fine from that point on can some one tell me how to make it quit slipping. thanks.

ps.. do i really need the vertical drop that comes with the lpk or can i straight line the faty so i can a flat grip back.
Back to Top
Bruce A. Frank View Drop Down
Platinum Member
Platinum Member
Avatar
KRL Reincarnated?

Joined: 27 March 2004
Location: United States
Status: Offline
Points: 3063 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Bruce A. Frank Quote  Post ReplyReply Direct Link To This Post Posted: 29 May 2005 at 7:05pm

Originally posted by Throesch Throesch wrote:

ok i installed the lpk into my a5 got it working go me i think. i alos have the palamer fatty installed on it and the e-grip. well here is the problem i ran into when i first got the lpk installed and loaded co2 to it (HPA tank not in yet) all went well i cocked it and fired well then the gun just went off the wall i had to manualy recock it or it woulnd push the power tube back all the way to the trigger. well after many times of cutting the spring it would go back to the trigger like its supposed to. well now when i first load co2 to the gun cock it and fire it slipps i then recock it and its fine from that point on can some one tell me how to make it quit slipping. thanks.

ps.. do i really need the vertical drop that comes with the lpk or can i straight line the faty so i can a flat grip back.

First let's get the terminology correct, you are saying that the hammer was not getting blown back far enough to engage the sear? If that is the problem then the solution is that the Palmer needs to be adjusted to provide a higher pressure to the gun. Cutting the spring is also an acceptable way to lighten resistance to allow for blow back cocking with lower pressures

Are you also saying that when you first install the pressure cylinder that the first shot is uncommanded; that the hammer "slips" from engagement with the sear? Then you cock the gun (pulling the hammer back to engage the sear) and thereafter it operates just fine? Have you modified the trigger in any way such as installing a lighter return spring on the trigger itself. When you install the cylinder is the trigger safety in the safe position?
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.04
Copyright ©2001-2021 Web Wiz Ltd.

This page was generated in 0.359 seconds.