Instaling DT on A5

Remove grip pins. Slide the safety out. pull the trigger set up out of the grip. If you have an e-grip, go pick up your pin that just shot out of the grip.

If you have an e-grip take a nail and a small hammer. Tap out the pin on the trigger, remove the spring and slider. Skip this if you have a regular grip.

Seperate the sides of the trigger assembly, lift out the old trigger, drop in the new ones. resituate the trigger spring.

Next, remove all the small philips screws that hold the halves of the grip together, as well as the hex that holds on the ASA. Lift out the old trigger guard and drop in the new one.

reassemble everything. Take this opportunity to trim the trigger pull.

Is there diferent designs  or versions of the double trigger for the A-5? My Dt will not fit the A-5 E-grip. I have remover\d the slider and spring. Still will not work.