![]() |
Making an electro grip frame fit |
Post Reply ![]() |
Author | |
Texx ![]() Member ![]() ![]() Joined: 31 August 2002 Location: United States Status: Offline Points: 306 |
![]() ![]() ![]() ![]() ![]() Posted: 06 August 2005 at 8:11pm |
I have a JT 3.5 as a back up gun to my Tippmann. Nobody sells an electro grip for it, and I know for sure that Piranha grips don't fit it. I'm not sure about spyders though, I'll have to check.
My idea is to either: A) Do some cutting and drilling to try and make another brand's handle fit or B) Take the guts out of another handle, and try to fit them into the existing one on the JT. What do ya'll think? Any other ideas, or comments? Texx |
|
98c 16" Carbon Fiber xchamber RT VL revolution 12volt w/xboard |
|
![]() |
|
Enos Shenk ![]() Platinum Member ![]() ![]() ~-o@ Joined: 10 June 2002 Location: A comfy chair Status: Offline Points: 14109 |
![]() ![]() ![]() ![]() ![]() |
Its just a spyder clone, i doubt it would be difficult at all to adapt a spyder e-frame for it.
|
|
![]() |
|
![]() |
|
The Guy ![]() Platinum Member ![]() ![]() Soup Can Guy Joined: 18 March 2004 Status: Offline Points: 6666 |
![]() ![]() ![]() ![]() ![]() |
not hard at all. its already been done. I think the offset distance for a screw is off by maybe an 1/8".
|
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |