My M98C M4

I've been working on this gun for a long time. I was first inspired to make
an M4 mod by shortyBP's M4/ProCarb which was posted several years
ago.

First, I would like to say that this gun is FAR from perfect. It is actually
pretty ghetto in many ways, and I use electrical tape in several places.
Hence, I usually don't have these mods attached in warm weather .
Therefore, if you don't like it, say so, but don't flame. These forums can
get sort of inmature at times. I opted for "ghetto" instead of $$$ many
times, but I also tried to make it come together well.

In short, I wanted my M98 to look like an M4, not like a M98 with a bunch
of M4 parts, like so many other milsims out there look like.

Specs listed bellow, ask as many questions as you like...











Specs:
M98C, polished internals
J&J Two Piece
Palmers Stab
LPK with modded rear bolt to accept stock
RT
Custom trigger tweeking (pen spring mod, etc)
Red Dot/Carry handle
Raised sight rail
M4 foregrip
Vertical foregrip
Custom Mag
M4 collapsable stock

Notes (since I know people will be asking):
I cut notches in the M4 forgrip so that it will slide further back, therefore       
making the gun look shorter.
The front of the mag is cut out so that I can, if I wan't, screw the palmers
directly into the gun. The electrical tape around the cut out part is so my
remote will not chafe when it is attatched directly to the gun.
No, my front sight is not entirely electrical tape .
The magazine well is sheet metel coverd with notebook/binder lining.
The Carry handle and vertical foregrip are from cheap airsoft guns.



Edited by 10kpbler

They work for me. Looks good. Try and get a better picture of the side view.

You should slide the carry handle sight back closer to the stock.


Edited by Bango

Sweet Jesus, how many rolls of electrical tape did you use?

Pretty nice.

a little sloppy but still all in all a good job

not bad looks pretty cool

looks allot more like an m4 than most of those aftermartket kits

get rid of the frount grip...make the magizine enclosed...eh besides that very cool looken. nice job

Mr.Shake56 wrote: Snake6 wrote: Sweet Jesus, how many rolls of electrical tape did you use?

you know you could make that magazine look a lot better drill a hole through that part, put a small bolt through there, and secure it with a nut, saw off any eccess of the bolt, it will look a WHOLE lot better, and get rid of the virticle grip on the shroud

Edited by sneaky_sniper

looks pretty cool not too sure about THAT MAG THOUGH ......