|
N00b about sight rails? |
Post Reply 
|
| Author | |
adblink 
Member 
Joined: 03 May 2006 Location: Canada Status: Offline Points: 123 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: N00b about sight rails?Posted: 13 July 2006 at 11:03pm |
|
i find it impossible to aim with my stock and mask, I end up just watching the balls from over top of the gun and trying to compensate after each shot do these after market sight rails actually work? I mean are they actually used to look and aim down, or just for mounting other mods? can you get them so they are actually accurate? is this one any good? or are they basically all the same
Edited by adblink - 13 July 2006 at 11:12pm |
|
 |
|
|
GI JOES SON
Platinum Member 
Got me flowers for my birthday Joined: 10 July 2005 Location: United States Status: Offline Points: 4946 |
Post Options
Thanks(0)
Quote Reply
Posted: 13 July 2006 at 11:10pm |
|
yea, theyre not that great, that particular one is used on the m16 assault rifle,your supposed to use the peep hole with the front sight on the front of the barrel, using just that is kind of ineffective. sights overall are pointless, since it depends on the amount of air in the tank, so pretty much youll be compensating a lot. that stuff is pretty much for mil-sim, not for actual sighting, but i guess it could be done... |
|
|
|
|
Tippyprouser
Member
Joined: 09 June 2005 Location: United States Status: Offline Points: 378 |
Post Options
Thanks(0)
Quote Reply
Posted: 13 July 2006 at 11:38pm |
|
GI is right, see if you got that, you would want to then get a M16 barrel shroud so then you could actually aim good. I have this same problem with my stock, so i took it off, until i can mod it. i have a BT folding stock. and by modding it i mean using little washers to lower the thing a little bit until i have enough room to get my mask down. then measure how big of a gap and have my bro make a threaded piece to go in it, more sturdy.
and another thing, what kind of mask do you have? cuz some masks may be better to get your head more down so you can see the sights. cuz i saw this one guy could see fine with his Car stock on his A-5. don't know what mask he had though.... |
|
|
Setup:
Tippmann Custom Pro E-trigger 12" All American BT Folding Stock GTA Inline Expansion Chamber Kit Dead on Pro seal Cyclone Feed System Remote Line Polished internals |
|
|
|
|
pooperscooper
Member
I’m not sure where to post this... Joined: 23 March 2005 Location: United States Status: Offline Points: 647 |
Post Options
Thanks(0)
Quote Reply
Posted: 13 July 2006 at 11:48pm |
|
Just take your gun sometime and shoot like 500 rounds at a target and you will have a good idea where the balls are going to go when you fire.
|
|
|
Chuck Norris doesnt read books, he stares them down untill he gets the information he wants.
|
|
|
|
|
FyreFly
Gold Member 
Joined: 15 November 2003 Location: United States Status: Offline Points: 1383 |
Post Options
Thanks(0)
Quote Reply
Posted: 13 July 2006 at 11:49pm |
|
You could always take the stock off and use your tank as a stock instead...
That rail, like stated above, is only a rear sight, you'd need something to line it up with at the tip of the barrel. |
|
System X NME LE WGP Orracle Cocker Tippmann A-5 E-Grip & LPK Tippmann 98C Flatline & LPK |
|
|
|
|
adblink
Member
Joined: 03 May 2006 Location: Canada Status: Offline Points: 123 |
Post Options
Thanks(0)
Quote Reply
Posted: 14 July 2006 at 12:19am |
|
aaah ok, so it wouldn't do me any good except for maybe looking good and using it as a handle, and I'm buying a lapco bigshot barrel when I go pickup my gun so it wouldn't help I'm in the market for those new Flex-8 camo masks, I just using some pos i got with my gun, no thermal lens on it so it fogs like crazy I love the look of my stock and also find is easier to use then just using a the small 12 ounce tank. I find it easier to run with and keep the gun aligned with what I need it to, its just a few times I need to look down the sight for a one or two precision shot and it wasn't working Edited by adblink - 14 July 2006 at 12:22am |
|
|
|
|
bassist11
Member
Joined: 23 June 2006 Location: United States Status: Offline Points: 392 |
Post Options
Thanks(0)
Quote Reply
Posted: 14 July 2006 at 1:20am |
|
get a remote. then you can hold your gun in front of your face exactly how you want to.
|
|
|
|
|
|
|
Tippyprouser
Member
Joined: 09 June 2005 Location: United States Status: Offline Points: 378 |
Post Options
Thanks(0)
Quote Reply
Posted: 14 July 2006 at 2:33am |
what are you talking about? how does getting a remote make it so he can put it in front of his face exactly how he wants it. the remote just moves the tank off his gun. and he still has the stock so he really couldn't put it anywhere in front of his face. |
|
|
Setup:
Tippmann Custom Pro E-trigger 12" All American BT Folding Stock GTA Inline Expansion Chamber Kit Dead on Pro seal Cyclone Feed System Remote Line Polished internals |
|
|
|
|
Ghost-Rider
Member
Strike 2, Filter Dodge 8/12 Joined: 15 May 2005 Location: United States Status: Offline Points: 956 |
Post Options
Thanks(0)
Quote Reply
Posted: 14 July 2006 at 4:27pm |
|
Yea youd need the front sight as our AR-15's have if you had the front itd be a good sight ..Note pointy thing on barrel:
(my AR-15  ) |
|
|
|
|
|
|
Stormcharger
Member
Joined: 10 September 2004 Location: United States Status: Offline Points: 394 |
Post Options
Thanks(0)
Quote Reply
Posted: 15 July 2006 at 1:09pm |
|
Invest in a raised sight rail and any of the cheap red dot type sights. This will bring the sight into a higher position, allowing it to be used with a mask on.
|
|
|
|
|
adblink
Member
Joined: 03 May 2006 Location: Canada Status: Offline Points: 123 |
Post Options
Thanks(0)
Quote Reply
Posted: 15 July 2006 at 5:13pm |
|
you cannot attach those red dot sights on this one right? it needs to be like the lapco ones? also does those red dot sights ACTUALLY work? I had one for my pellet gun and it was **edited**, you could never get it lined up properly |
|
|
|
|
FyreFly
Gold Member
Joined: 15 November 2003 Location: United States Status: Offline Points: 1383 |
Post Options
Thanks(0)
Quote Reply
Posted: 15 July 2006 at 9:43pm |
|
Don't use a $2 red dot. Find a nice $20+ one.
|
|
|
System X NME LE WGP Orracle Cocker Tippmann A-5 E-Grip & LPK Tippmann 98C Flatline & LPK |
|
|
|
|
an94
Member
Joined: 24 June 2006 Location: United States Status: Offline Points: 514 |
Post Options
Thanks(0)
Quote Reply
Posted: 15 July 2006 at 10:49pm |
|
Im not sure who makes them but someone makes a side mount. It moves the red dot up and over to the left about 2 or 3 in. so you can still use a stock much easier.
|
|
|
1 paintball gun package=$150
1 case of paint=$50 air & entry fee=$15 lighting up newbies all day long= Priceless |
|
|
|
|
Duechy
Member
Joined: 09 October 2005 Location: United States Status: Offline Points: 187 |
Post Options
Thanks(0)
Quote Reply
Posted: 15 July 2006 at 11:10pm |
|
If you want to use a sight and a stock correctly then you will definitely need a raised rail. I used a BT raised sight rail and Simmons 20mm Red dot combo for several years with a lot of success. What ever you do.. don't get a scope. |
|
|
One shot, One kill.... Oh, wait. What fun is that? TEN shots, one kill, and a bunch of welts on your back.
|
|
|
|
|
adblink
Member
Joined: 03 May 2006 Location: Canada Status: Offline Points: 123 |
Post Options
Thanks(0)
Quote Reply
Posted: 16 July 2006 at 3:04am |
|
ya I originally was thinking scope but got out of that idea fast so these red dot things, are they easy to setup? I mean you must waste a whole hopper trying to get them to shoot on target, then what, as soon as it hits something, you have to go through the whole process again right? also just making sure, it just basically puts a red dot on the interior of the glass inside the sight right? |
|
|
|
|
DeTrevni
Moderator Group 
b-YOU-ick. Was that so hard? Joined: 19 September 2005 Location: Houston, Texas Status: Offline Points: 11957 |
Post Options
Thanks(0)
Quote Reply
Posted: 16 July 2006 at 3:45am |
|
Hm. For someone who has never used a red-dot, you just hit the nail on the head! I've never really found the point of a site, and I've used my fair share from scopes to red-dots, and it is SO much easier just to sight it down your barrel... And since you mention you like stocks, may I suggest a gas-thru or grip-mounted t-stock? It doesnt give the look of real gun, but it's adjustable, comfy and doesn't get in the way of the mask. Edited by DeTrevni - 16 July 2006 at 3:48am |
|
|
Evil Elvis: "Detrevni is definally like a hillbilly hippy from hell"
|
|
|
|
|
Markle
Member
Joined: 13 July 2006 Location: Canada Status: Offline Points: 32 |
Post Options
Thanks(0)
Quote Reply
Posted: 16 July 2006 at 12:21pm |
sights aren't pointless they do help you aim and they help you level your gun
|
|
|
|
|
Zoom2136
Member
Joined: 31 March 2004 Location: Canada Status: Offline Points: 52 |
Post Options
Thanks(0)
Quote Reply
Posted: 17 July 2006 at 5:18pm |
|
Lapco offset mount rail... http://www.pbreview.com/products/reviews/2776/ And use a red dot with it.... |
|
|
In the market for a new A5
- sold mine last year :o( |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
bassist11 wrote: