FeVeR’s 98 Project

Well ive wanted a 98 for a long time, wanted to mill it and paint it and customize it.  So i finnaly got one, and i finnaly started.

Before:


Day 1: Lettering and Velocity Lip


I messed up on the velocity lip.  But i can fix that.

Day 2: Front Grip.


I think i did a good job for my frist time.

Day 3: Rear site.  
Still to come.


My plans.

Mill the rest of it.

Not sure what color i want to paint it yet.

Get a new smaller board, so i can fit the battery (hoppefully) into the grip.  And then fill in the cocking slot.

2 way ram with QEV's

BSI Stick trigger.  or mod a CP sling blade some how

Low Pressure Kit

Palmers Reg

Palmers Rock lpr

Cut the part between the front grip and the power tube hole, so you can see the tube from the regulator.

Fill in the top, so its square.  Then round it.  And cut a hole in it, and make a top cocking thing.  Even tho you dont have to cock it, it will just look cool.

Almost forgot the center feed.

Some barrel kit.

I *think* thats about it.

im doing kinda the same thing right now. and just so you know, getting everything to fit inside the gun is hard. i already have my board repositioned into the grip outside the gun. and my ram is up near the ram. but the battery still needs to be fit inside. it takes TONS of milling to make that work out. ive been working on it for like a week and im still not done. only like halfway, be prepared for lots of milling to fit the battery inside

i should have bought that ebolted 98c

you had better post finished pics of it

you should do something origional with the rear site, but make sure it looks nice first.

paint it something speedballish and tell people it's the new shocker

Hmmm...

Battery in foregrip mod?

Look in the Uber upgrades sticky. Last page. Written by me. Very easy.

Its been in there for awhile, and noone has done it

cool man. What xbox games do yow have?

nice

FeVeR wrote: Hmmm... Battery in foregrip mod? Look in the Uber upgrades sticky. Last page. Written by me. Very easy. Its been in there for awhile, and noone has done it I would, but i want to put a palmers reg there.

You can always put a vertical asa connected directly to the valve.

Thats what I'm planning when im done with my other zillion projects im starting.

Is it just me, or does it look like its bent to the left in the third pic down?

lookin good...very nice milling...almost looks like my 98c. i would like to
see it when your done...

Edited by WKS_weiner - 29 August 2006 at 3:56pm

EBAY, or it looks the same from the one i had my eye on, pretty cool

Edited by Poozy - 30 August 2006 at 8:37pm