Ball Bearing Pump |
Post Reply |
Author | |
pattison
Member Joined: 30 August 2002 Location: Korea, North Status: Offline Points: 384 |
Post Options
Thanks(0)
Posted: 14 September 2006 at 11:44am |
so far it is only a concept, i'll post an update if anything comes of this.
all dimensions are in centimeters. should not be too hard to make, with the only necessary machining being the 1/8" side plates, but it would require putting a 90 degree bend in the end of the pump rod. if you don't know what a phantom liiks like... here |
|
Eat The Brisket
|
|
carl_the_sniper
Platinum Member Strike 1 - 7/29, Bad Linky Joined: 08 April 2006 Location: Canada Status: Offline Points: 11259 |
Post Options
Thanks(0)
|
complicated and i can kinda see whats happening but not really enough to say if itl work or not |
|
<just say no to unnecessarily sexualized sigs>
|
|
Tippmania
Member No, IM right! Joined: 13 September 2006 Location: United States Status: Offline Points: 9 |
Post Options
Thanks(0)
|
Could work..... just need some really good enginners...
|
|
Tippmann A-5
- Shocktech Drop + On\Off - Super R\T - Q.E.V. - Red Hot Powertube - Stock - Flatline + Metadyne Shroud - R.I.S. Foregrip - X-Core - Macro - BT Fixed Sight Rail |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |