tippmann 98 not working. please help |
Post Reply |
Author | |
GOMEZ15
Member Joined: 29 March 2009 Location: New Mexico Status: Offline Points: 124 |
Post Options
Thanks(0)
Posted: 02 April 2009 at 7:09pm |
my Tippmann 98 custom has a response trigger, a expansion chamber, and a cyclone feed.
i recently took it apart, (i found my earlier problem of it not cocking back all the way. a stretched o-ring on the rear bolt ) i found while repairing my first problem, that the section of the bolt where the banjo T screws in was cracked. i super glued the crack.(not the best idea). i think this is my problem for my response trigger and cyclone feed not working... on no air in my tank ( or not enough air). i have another bolt capable of an adaption of a response trigger. i have a question. how do i replace the bolt? the parts in the original bolt seem to be glued in. can someone tell me how to get the bolt parts into the new one? thanks for taking the time to read through my cry for help with whatever gramer or punctuation errors i may have. Edited by GOMEZ15 - 03 April 2009 at 2:43pm |
|
FORUM snowboarding
|
|
FarSeer
Member Joined: 18 April 2006 Location: Montana Status: Offline Points: 649 |
Post Options
Thanks(0)
|
When you say "bolt" do you mean "powertube?" The valve inside shouldn't be glued in, but the braided steel hose has loctite on it which requires excessive force or heat above 325* (i think) to remove it. Then just push out the valve.
|
|
GOMEZ15
Member Joined: 29 March 2009 Location: New Mexico Status: Offline Points: 124 |
Post Options
Thanks(0)
|
thanks, i think i fixed my problem. i just need co2 to test it.
|
|
FORUM snowboarding
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |