A5 stock barrel improvement |
Post Reply | Page <12 |
Author | |
triggerhappy1
Platinum Member Joined: 07 May 2004 Location: United States Status: Offline Points: 3376 |
Post Options
Thanks(0)
|
does it work for the 98c stock barrel? iv got one just lying around.
|
|
|
|
Stiffler
Member Joined: 24 June 2004 Location: United States Status: Offline Points: 843 |
Post Options
Thanks(0)
|
^^yes, read my post earlier
|
|
|
|
triggerhappy1
Platinum Member Joined: 07 May 2004 Location: United States Status: Offline Points: 3376 |
Post Options
Thanks(0)
|
ok im going to try next time i can get my hands on a pipe cutter. im seting up a test too to post later.
|
|
|
|
deakins
Member Joined: 03 August 2002 Location: United States Status: Offline Points: 300 |
Post Options
Thanks(0)
|
dont use a pipe cutter because it will form a lip around the inside of the barrel. if you have access to a lathe use it. if not use a hacksaw(carefully) then clean and square the cut with a fine mill file. just make sure there arent any burrs around the inside of the barrel
|
|
show initiative, determination. PROUD of ya! broken arrow
|
|
Kirdro
Member Joined: 07 October 2004 Location: United States Status: Offline Points: 62 |
Post Options
Thanks(0)
|
Try this one, its rifled, and accurate as any other barrel, except a flatline http://www.endgameinc.com/Paintball-Products/Default.asp
|
|
Hey, didn't I see you riding the short bus, wearing a helmet, and licking the windows?
A-5, Response trigger, Flatline, Soon to own a expansion chamber. |
|
Post Reply | Page <12 |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |