"Power Tube" components have broken

You didn't break it, just look at the schematics of ur gun in ur gun manual and look at the part where it shows the valve,.

First drop the lil valve pin in the power tube n make sur the pin goes through the hole at the bottom of the valve, then slide the washer on top of the pin n make sur its flat, then the tricky part is fitting the o ring bak on, i can't explain the perfect way of doing this but wut u have to do is fit the o ring above the washer *not around the washer*, n mess with it a lil bit *have patience* n it should pop bak in place, just make sur when ur putting ur gun bak together that you don't push too hard on the pin on outside of the power tube *where the pin sticks out of the power tube* cause that'll make the pin/washer/ o ring pop out again and u'll have to do this all over again, don't want that.

If u put everything bak to gether right u should be able to slightly*NOt hard* push on the pin poking outside of the power tube with out it popping, if its really loose u didn't do it right. Or u could screw in ur air again n try it out. Looking at the schematics should help bit more then this post but hope this helps anyways.

ah sry i amost forgot, before you put the washer n o ring in, make sur after you put the pin in, you put the spring on top of it, then put the washer, followed by fitting the o ring. http://www.tippmann.com/support/a5parts.asp

You can see wut im talking about in here, u should have this in ur owners manual, u might want to save the pic so u can zoom it. Also i forgot to say that u have to take the valve out of the powertube so u can install the components again*tats only way i am able to do it anyways*,best way to do it is just get some pliers (don't hate my spelling) and pull the valve out by the pin, can put some small cloth or something around the pin so u don't scratch to much, dunno if it'll make a dif or not. Then after u installed everything just push the valve bak into the power tube n make sur everything is lined up correctly *make sur while ur pushing the valve in ur not also pushing the pin in, cause it'll pop out again.*