|
flatline problem... |
Post Reply 
|
| Author | |
mayonaise 812 
Member 
Joined: 29 January 2005 Location: United States Status: Offline Points: 28 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: flatline problem...Posted: 09 February 2005 at 7:08pm |
|
ok i did it and it worked....so yeah thanks for the help |
|
 |
|
|
triggerhappy1
Platinum Member 
Joined: 07 May 2004 Location: United States Status: Offline Points: 3376 |
Post Options
Thanks(0)
Quote Reply
Posted: 09 February 2005 at 3:38pm |
|
just take off as little as possibe. use wire cutters, and take off the shoud first.
|
|
|
|
|
|
|
Dazed
Platinum Member
Romped around naked in thorn bushes Joined: 13 February 2003 Location: United States Status: Offline Points: 3876 |
Post Options
Thanks(0)
Quote Reply
Posted: 09 February 2005 at 10:44am |
|
That should work. Just make sure you aren't cutting off any latch or clip that the shroud needs to lock into position. I don't think there is anything like that back there, but double-check.
|
|
|
|
|
mayonaise 812
Member
Joined: 29 January 2005 Location: United States Status: Offline Points: 28 |
Post Options
Thanks(0)
Quote Reply
Posted: 09 February 2005 at 9:54am |
|
i recently have purchased a flatline barrel and a folding stock. The stock gets in the way of the shroud from locking into position.(the stock has like a block that raises up and down). if i cut of part of the end octagon part on the shroud do you guys think that it will still work? this for the 98 custom... Edited by mayonaise 812 |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options