ball chamber milling
Printed From: Tippmann Paintball
Category: Paintball Equipment
Forum Name: Upgrades and Customizing
Forum Description: Trick it out!
URL: http://www.tippmannsports.com/forum/wwf77a/forum_posts.asp?TID=110619
Printed Date: 06 September 2026 at 10:36am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: ball chamber milling
Posted By: pballraper
Subject: ball chamber milling
Date Posted: 15 August 2004 at 12:13pm
|
what do you guys think about milling the ball chamber in the link below? do u think that it will waste gas in any way or would the gas that is venting be excess gas? just tell me what you think. http://www.ballisticsports.com/milling.htm - http://www.ballisticsports.com/milling.htm |
Replies:
Posted By: pballa j.r.
Date Posted: 15 August 2004 at 12:18pm
|
no you wont waste/loose anything
------------- 
|
Posted By: Kevin Z
Date Posted: 15 August 2004 at 12:57pm
|
As the ball is fired, the action is blown back. The bolt comes out of the barrel while there is still residual pressure from firing the ball. this pressure has no where to go but back up the feed tube blowing the balls back into the hopper. I have milled my primary http://www.model98.net/mod10.html - M98 custom Recently I bought an http://home.comcast.net/~k.zoellner/KevinZ_m98.html - M98 , just to mill the gills. Yes it helps keep the balls going in the right direction, no it does not waste gas. ------------- United States Marine Corps.... When it absolutely, positively, has to be destroyed overnight! Just say NO to junk mods |