dragunfly autocoker
Printed From: Tippmann Paintball
Category: Paintball Equipment
Forum Name: Gun Maintenace and Repair
Forum Description: Important info for keeping your marker in top shape
URL: http://www.tippmannsports.com/forum/wwf77a/forum_posts.asp?TID=136866
Printed Date: 14 June 2025 at 1:44am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: dragunfly autocoker
Posted By: freakman21
Subject: dragunfly autocoker
Date Posted: 30 June 2005 at 12:50pm
|
im ususalll the person everyone brings their broken guns to to see if i can fix em, well im not the best w/ autocokers, but the one im havin troubles w/ is that it leaks from the front block, under where it sais "dragunfly" does neone kno wat is wrong and how to fix it? thanks ------------- 
|
Replies:
Posted By: Monk
Date Posted: 30 June 2005 at 4:49pm
| Teflon tape it? |
Posted By: freakman21
Date Posted: 30 June 2005 at 6:46pm
|
their isnt a place to put the tape, it jus leaks when you dont have the trigger pulled, but leaks when u dont have it pulled -------------
|
Posted By: Enos Shenk
Date Posted: 01 July 2005 at 4:23am
Huh? You like, need to be WAY more descriptive. ------------- 
|
freakman21 wrote:Posted By: freakman21
Date Posted: 02 July 2005 at 12:28am
|
ok, it leaks when u air it up but when u pull and hold the trigger it stops leakin but when u let off the triger, after it shoots it starts leakin again...a vicous cycle. im not very familure w/ these guns, all i kno is that their are a few small holes on the bottem of where is sais "dragunfly" and the middle one is where a hose goes into it, but its leaking out of one of the others that dont have nehting in it. -------------
|
Posted By: †Sniper†
Date Posted: 02 July 2005 at 1:35am
|
Hold that part under water, determine exactly where the leak is coming from. Plug it up with teflon and/or loctite. Although, if this is the dragunfly from that horrible company, it may be that the ram/reg/3-way or whatever part it is was jsut constructed poorly, in which case you should replace it. |
Posted By: Monk
Date Posted: 02 July 2005 at 1:47am
|
3-way, might not be adjsuted right. Needs to be moved in or out to stop the leaking. But what do I know. |
Posted By: The Guy
Date Posted: 02 July 2005 at 2:49am
|
yeah, its not the front block. Your 5-way isn't correctly adjusted. Either the shaft is crooked and causing a leak. Or one of the o-rings is partially covering a hole when at rest position. Read up on how to time an autococker and stop when they get to how to adjust the 5-way (usually referred to as a 3-way). ------------- http://www.anomationanodizing.com - My Site 
|
Posted By: the william
Date Posted: 04 July 2005 at 6:55pm
|
give it back and tell him it's broke... and u can't fix it |