Custom Pro bolt problems
Printed From: Tippmann Paintball
Category: Paintball Equipment
Forum Name: Gun Maintenace and Repair
Forum Description: Important info for keeping your marker in top shape
URL: http://www.tippmannsports.com/forum/wwf77a/forum_posts.asp?TID=149298
Printed Date: 22 December 2025 at 7:03am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: Custom Pro bolt problems
Posted By: KobraII
Subject: Custom Pro bolt problems
Date Posted: 29 January 2006 at 6:02pm
| On my Custom Pro, sometimes the bolt doesn't come back far enough. But usually all I have to do is just pull it back and I'm back in business. What could be the problem? Could it be caused from low air pressure? |
Replies:
Posted By: Bango
Date Posted: 29 January 2006 at 6:45pm
|
Make sure your front bolt isn't in backwards.
------------- http://imageshack.us"> 
|
Posted By: evillepaintball
Date Posted: 29 January 2006 at 7:25pm
| make sure all of your screws are tight |
Posted By: Bruce A. Frank
Date Posted: 30 January 2006 at 1:30am
|
If you are running a regulator, set it 50 lbs higher than you are running right now. Lubricate the rear bolt's "O" ring. |
KobraII wrote:Posted By: Tippman man
Date Posted: 30 January 2006 at 7:59pm
|
Make sure your Co2 isn't low. sometimes that's the problem. ------------- I love my Tippman 98 custom! |
Posted By: KobraII
Date Posted: 31 January 2006 at 3:16pm
| Ok, I was just wondering. My bolt isn't backwards, everything is correct on the inside. I run Co2, and I got to thinking about it, and it usually happens a couple times before my gun burps |
Posted By: Ilford Rule
Date Posted: 31 January 2006 at 6:33pm
|
If it only happens right before the gun burps then its low Co2. If it always happens then it could be a liquid Co2 problem but thats unlikely. ------------- CPro (w/ polished internals) 14" Bigshot BT SBS Various Rails NcSTAR D4B Macro AA 68/45 
CCI Phantom 45 Grips |
Posted By: Bruce A. Frank
Date Posted: 05 February 2006 at 12:50am
|
How long have you been using a Tippmann? |
Posted By: KobraII
Date Posted: 05 February 2006 at 1:07am
| I've been using my Tippmann since Christmas, so about a month and a week or two |
Posted By: DsXz
Date Posted: 08 February 2006 at 9:16am
| when u pull it back again u only have to pull it back a little bit right? if so then I have the same problem. and its not because of co2 or ball breaks/jams. still trying to figure out what it is tho :/ |
Posted By: Monk
Date Posted: 08 February 2006 at 12:53pm
| Makes sure your valve bolts are on tight(not too tight cause you can strip them very easily). |