totally clueless :’(
Printed From: Tippmann Paintball
Category: Paintball Equipment
Forum Name: Gun Maintenace and Repair
Forum Description: Important info for keeping your marker in top shape
URL: http://www.tippmannsports.com/forum/wwf77a/forum_posts.asp?TID=151923
Printed Date: 12 December 2025 at 3:22pm
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: totally clueless :’(
Posted By: DsXz
Subject: totally clueless :’(
Date Posted: 17 March 2006 at 3:23pm
|
ok, im convinced my guns broken. i checked my sear and its fine.. im really stumped :( ------------- http://imageshack.us"> 
|
Replies:
Posted By: Crossfire636
Date Posted: 17 March 2006 at 3:26pm
| clean all the moving parts on the inside of the gun, then re-lube them and drop about 7 drops of oil in the asa and shoot about 50 times...when i had a m98 it did it a few times and i did ^^^^^ and it was fine again |
Posted By: DsXz
Date Posted: 17 March 2006 at 3:50pm
|
jus tried it, didnt work ------------- http://imageshack.us">
|
Posted By: old fart
Date Posted: 17 March 2006 at 4:06pm
| check the tension sprin on the sear, could be disconnected or soft |
Posted By: DsXz
Date Posted: 17 March 2006 at 4:13pm
|
nope, still as tight as b4 ------------- http://imageshack.us">
|
Posted By: pwned!!!
Date Posted: 17 March 2006 at 4:37pm
| maybe your missing a valve screw my brother had a simaliar problem and he found that he was missing a valve screw or it was loose or something, anyway i would check the valve |
Posted By: DsXz
Date Posted: 17 March 2006 at 4:57pm
|
i dunno what the valve looks like lol ------------- http://imageshack.us">
|
Posted By: pwned!!!
Date Posted: 17 March 2006 at 5:03pm
| youll need to take apart your gun and its where your velocity screw is i think it may be on the powertube |
Posted By: DsXz
Date Posted: 17 March 2006 at 5:07pm
|
mkay.. ------------- http://imageshack.us">
|
Posted By: pwned!!!
Date Posted: 17 March 2006 at 5:11pm
| sorry i cant be more help, thats all i can think of |
Posted By: old fart
Date Posted: 17 March 2006 at 5:17pm
| since noe of the above suggestion didn't wotk , get a kit and dissassemble the power valve, install new o rings on the same, possibly getting improper blow back |
Posted By: Bruce A. Frank
Date Posted: 17 March 2006 at 7:08pm
|
Here are the screws you are looking for. If these are loose or missing the valve can move when the hammer hits it and cause the problems you are having.
|
DsXz wrote:
Posted By: DsXz
Date Posted: 17 March 2006 at 9:34pm
|
those were already rly tight i dont wanna strip em. i guess ill just replace the bolt o rings n see what happens. :/ more advice is still appreciated tho!! :) ------------- http://imageshack.us">
|
Posted By: Bruce A. Frank
Date Posted: 17 March 2006 at 11:17pm
|
After you replace the "O" ring, use a little lithium grease on both it and the inside surface of the power tube...works better than the light oils usually recommended. |