Gun Maintenace and Repair - ASA and E-Grip

Print Page | Close Window

ASA and E-Grip

Printed From: Tippmann Paintball
Category: Paintball Equipment
Forum Name: Gun Maintenace and Repair
Forum Description: Important info for keeping your marker in top shape
URL: http://www.tippmannsports.com/forum/wwf77a/forum_posts.asp?TID=157425
Printed Date: 28 February 2026 at 11:05pm
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com

Topic: ASA and E-Grip

Posted By: Rudy
Subject: ASA and E-Grip
Date Posted: 14 July 2006 at 11:49pm

I just got my new E-grip today and finished setting it to the settings I want. Anyways when i went to put my ASA adapter back into the handle the bolt that goes through the ASA would not go. If i tightened it all the way eventually the grip would start to split at the seams. I think my problem is that the ASA is in the grip a little bit crooked and that is what is causing the bolt to go in hard.

The only solution that I could conjur up was to possibly drill out the hole that goes through the ASA. Or might this be a mistake.

Currently I have my remote going directly into the gun. But that isn't my preference.

Any help will be greatly appreciated. Thx.

Replies:

Posted By: cus98tom
Date Posted: 15 July 2006 at 8:05am

Loosen the three philips head screws and then insert the ASA, this may help with the alignment. You may be over tightening it , try holding the short end of the wrench and tighten , this will limit the amount of torque yoe can apply.

Posted By: Rudy
Date Posted: 15 July 2006 at 9:40am

Hey thanks, it worked.

Posted By: cus98tom
Date Posted: 15 July 2006 at 9:25pm

No problem, Glad I could help.