98 Pro E problem
Printed From: Tippmann Paintball
Category: Paintball Equipment
Forum Name: Gun Maintenace and Repair
Forum Description: Important info for keeping your marker in top shape
URL: http://www.tippmannsports.com/forum/wwf77a/forum_posts.asp?TID=164704
Printed Date: 22 November 2025 at 4:55am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: 98 Pro E problem
Posted By: Shrek1
Subject: 98 Pro E problem
Date Posted: 23 February 2007 at 4:44pm
I have a costum pro E With APE board, BT sealed bolt and JCS power tube with big air mo, Qev and JCS ratchet on the Cyclone feed. My problem is the gun in full auto at 15 BPS will stop firing and need to be recoucked. I have replaced the rear ddive spring and rear bolt and O ring and sear. Any help would be great.
|
Replies:
Posted By: michaela2z
Date Posted: 24 February 2007 at 5:42am
|
Just check that everything is oiled up and moving freely, with all the internal mods you got going something might just be a lil stiff and not alloing the gun to cycle fully so go round everything with suitable oil/grease. Also check that the new power tube is running smoothly, Tippmann generally make very good internals from stock so there might be something causing extra drag with the blue tube but that should be fine, id just check for general binding. ------------- Well...Putfile deleted all my pictures so I don't have a signature atm! |
Posted By: Bruce A. Frank
Date Posted: 26 February 2007 at 2:14am
|
Running CO2? -------------  
|
Shrek1 wrote:Posted By: phil_stl
Date Posted: 26 February 2007 at 2:20am
| Was the rear drive spring that you put in noticeably lighter than the old one? |
Posted By: Shrek1
Date Posted: 27 February 2007 at 7:34pm
| The JCS tube is was added to help fix the problem and I use both CO2 and HPA |