Print Page | Close Window

A-5 Egrip Malfunctioning

Printed From: Tippmann Paintball
Category: Paintball Equipment
Forum Name: Gun Maintenace and Repair
Forum Description: Important info for keeping your marker in top shape
URL: http://www.tippmannsports.com/forum/wwf77a/forum_posts.asp?TID=175116
Printed Date: 11 March 2026 at 12:06pm
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com


Topic: A-5 Egrip Malfunctioning
Posted By: MkSAW
Subject: A-5 Egrip Malfunctioning
Date Posted: 27 April 2008 at 12:06am

Im using an egrip for my a-5. It was working fine for almost the first 2 months since i purchased it. Now the egrip will malfunction after the first couple of shots.When you pull the trigger, it starts working at first. After you pull the trigger about 4 times, it stops working!!! The full auto and burst modes dont work at all.I replaced the battery, checked the pin to make sure it wasn't bad,checked the wires reset the trigger to default settings,etc. I think it might be a bad circuit board.

Any advice on what could be the problem?




Replies:
Posted By: The Guy
Date Posted: 27 April 2008 at 12:14am
Any obvious damage, like water or board components that are blackened/burnt?

Take your grip off your gun and try firing it by pushing directly on the microswitch. Some trigger don't work well with the switch.

Have you made any upgrades to your A5 since getting the e-grip?

If all else fails, and it is only 2 months old, send it in under warranty.


-------------
http://www.anomationanodizing.com - My Site


Posted By: MkSAW
Date Posted: 27 April 2008 at 12:19am

No water damage. i did press the microswithch manually. The trigger sounds fine when it isnt under pressure. I have heard rumors about using co2 will cause it to not work properly. However , im not sure if its true




Print Page | Close Window

Forum Software by Web Wiz Forums® version 12.04 - http://www.webwizforums.com
Copyright ©2001-2021 Web Wiz Ltd. - https://www.webwiz.net