Power tube problem
Printed From: Tippmann Paintball
Category: Paintball Equipment
Forum Name: Gun Maintenace and Repair
Forum Description: Important info for keeping your marker in top shape
URL: http://www.tippmannsports.com/forum/wwf77a/forum_posts.asp?TID=179685
Printed Date: 16 September 2026 at 6:09pm
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: Power tube problem
Posted By: pinballwizard
Subject: Power tube problem
Date Posted: 04 January 2009 at 10:36pm
I posted about not being able to quick strip my a5. after anin depth investigation I found that the rear end of my power tube is bent from being repeatedly rammed into the block of aluminium at the bottom rear of the reciever that supports the pin that holds the trigger group and grip onto the reciever. I was wondering if this would affect the performance of my gun or if I need to replace my power tube. if anyone can help I'll be greatly appreciative.
|
Replies:
Posted By: The Guy
Date Posted: 07 January 2009 at 5:37am
|
in depth investigation eh? Sounds more like you tied to force it out and broke it. As long as your rear bolt can freely move into the back and strike the valve pin, it should be ok. ------------- http://www.anomationanodizing.com - My Site 
|
Posted By: pinballwizard
Date Posted: 08 January 2009 at 2:49pm
|
ya well I didnt try way too hard its just chipped also i was bored and felt like saying something nerdy but the rear bolt is fine thanx anyway |
The Guy wrote: