Victor updates
Printed From: Tippmann Paintball
Category: Tippmann Paintball
Forum Name: Marker Gallery
Forum Description: Show us your guns!
URL: http://www.tippmannsports.com/forum/wwf77a/forum_posts.asp?TID=183547
Printed Date: 02 December 2025 at 4:10pm
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: Victor updates
Posted By: Lightningbolt
Subject: Victor updates
Date Posted: 08 November 2009 at 6:33pm
|
I've been messing with the Victor a bit. It shoots surprisingly smooth. Java volumizer, high pressure Max Flo.
 Custom offset plate. This was my solution to use standardized asa's. I also switched the grip frame to
asa screws from the hard to find stock 5/32 to 6/32.
  Stock hammer, valve and bolt. All modified to run very low pressure. Madman springs. I'll have conclusive numbers on operating pressure before winter.
 |
Replies:
Posted By: merc
Date Posted: 08 November 2009 at 9:25pm
|
ball park what PSI are you running? did you open up the valve/body any? ------------- saving the world, one warship at a time. |
Posted By: Lightningbolt
Date Posted: 08 November 2009 at 10:25pm
|
250-280 psi thru a Palmer and I'll be driving it lower. It chrono'd perfect right off the bench and I haven't touched any settings yet. The valve body is opened up. I'll probably get a delrin bolt, lower the operating pressure more and call it good. Too much work to go to any shorter of a bolt.
It bites that the volumizer doesn't have a gauge port but I have a rig set up to test operating pressure on any gun. Just get the gun operating optimum over a chrono then check the psi after.
|
Posted By: The Guy
Date Posted: 08 November 2009 at 11:40pm
|
looks too green.
------------- http://www.anomationanodizing.com - My Site 
|
Posted By: Lightningbolt
Date Posted: 09 November 2009 at 7:44am
|
Too green? It could end up with a pink feedneck =)
Possible names for the gun are
-Sanford and Son
-Garage
-JYD
|