Dissassembled Bravo One Internals
Printed From: Tippmann Paintball
Category: Tippmann Paintball
Forum Name: Marker Gallery
Forum Description: Show us your guns!
URL: http://www.tippmannsports.com/forum/wwf77a/forum_posts.asp?TID=186315
Printed Date: 26 June 2025 at 11:26pm
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: Dissassembled Bravo One Internals
Posted By: toosexyformycat
Subject: Dissassembled Bravo One Internals
Date Posted: 27 July 2010 at 2:13am
|
^^Heres the Pre-Dissassembly.
 Ooh! Now we're into the internals!
 Rear of the marker.
 Front end of marker. As you can see my Recievers Ball Latch was put in backwards. I realised this AFTER I re-assembled the marker. -.- Quick question though.. is my buffer O-Ring supposed to be loose just sitting there? 3rd picture shows it in position but after I cock, and shoot, I realise sometimes it gets pulled off. ------------- Equipment: -Tippmann Bravo One Tactical' To Get' List: -E-Trigger Mod -Cyclone Feed -VForce Profiler. |
\Replies:
Posted By: Mack
Date Posted: 27 July 2010 at 8:17pm
|
That o-ring is a "floater," it doesn't have a position it stays in other than just being around the mainspring and spring guide.
------------- 
|
Posted By: toosexyformycat
Date Posted: 27 July 2010 at 8:41pm
------------- Equipment: -Tippmann Bravo One Tactical' To Get' List: -E-Trigger Mod -Cyclone Feed -VForce Profiler. |
Mack wrote:Posted By: *Stealth*
Date Posted: 28 July 2010 at 10:16am
|
So it's a 98? ------------- |
Posted By: toosexyformycat
Date Posted: 28 July 2010 at 6:58pm
|
Yeah pretty much. Bravo one is just a slightly modified C98 in appearance. ------------- Equipment: -Tippmann Bravo One Tactical' To Get' List: -E-Trigger Mod -Cyclone Feed -VForce Profiler. |
Posted By: Mack
Date Posted: 28 July 2010 at 9:15pm
|
"Bravo One" is the moniker under which the Alpha Black is sold in Canada.
-------------
|
Posted By: oldsoldier
Date Posted: 05 August 2010 at 10:11am
|
I use a little rubber cement to secure the buffer o-ring to rear of reciever on my Carver One and Project Salvo, an o-ring floating around still has the potential of a jam or lock withing the reciever.
Also go to a good auto repair place and get an A/C o-ring repair kit, the small o ring from the kit fits tight on the spring/spring guide and is a better buffer. Other rings in kit fit the barrel o-ring slot, as well as front reciever o-ring. ------------- 
|