Bravo One - Problems with firing modes
Printed From: Tippmann Paintball
Category: Tippmann Paintball
Forum Name: New Player Forum
Forum Description: New to the sport? Get Professional Advice Here!
URL: http://www.tippmannsports.com/forum/wwf77a/forum_posts.asp?TID=186746
Printed Date: 14 June 2025 at 11:19am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: Bravo One - Problems with firing modes
Posted By: DeeJay
Subject: Bravo One - Problems with firing modes
Date Posted: 21 September 2010 at 5:35pm
|
Bravo One tactical Edition with E-trigger equipped with 0,8l air tank, regulator set to 800PSI and a tacamo Arc Dual feed port hopper capable of 11,6 BPS. Problem 1: In mode 2, triple fire, one press on the trigger only gives 1 shot. To get 3 round burst I have to fire 4 shots in one second, the 4th shot will trigger the burst. Description in the manual says 3 shots with only one press of the button. What is wrong? Problem 2: When set to mode 2 or 3, full-auto normal and fast. As written in manual, if I fire 4 rounds fast and hold trigger the auto mode starts. Problem is that after a few rounds (3-6) the marker hangs and the cocker vibrates in middle mode. To get gun working again I have to manually cock it. Air bottle is full. Does anything need to be adjusted? Marker is brand new out of the box and I really need some help. Thanks |
Replies:
Posted By: Mack
Date Posted: 21 September 2010 at 6:29pm
|
Don't know what to tell you about the triple fire mode. The online manual reads like you say but I always thought the Tippmann boards were set up the way you describe it operating. As far as the second problem, I'm not certain what you mean by "vibrating in middle mode." If you mean that the marker fires full-auto uncontrollably until you recock it, then it sounds like an air starvation issue. That is, your marker is using the compressed air at a faster rate than it is delivered so after a few shots you end up with out enough pressure to reset the hammer (rear bolt) on the sear and it fires until this is done manually. Outside of reducing your rate of fire, there is not much that can be done to ta stock marker to correct this. You could try adjusting the regulator up to 1000 psi but this won't help unless the tank regulator is capable of delivering at higher pressures as well. ------------- 
|
Posted By: patchesTPX97
Date Posted: 29 October 2010 at 11:24am
|
on my e trigger whenever i do 3 shot burst i have to fire twice before to get the burst, however on the videos online they just press it once for 3 shot burst. does anyone have any idea on how to fix it??? much appreciated:) ------------- Patches If its too loud... your too old |