carver one ups
Printed From: Tippmann Paintball
Category: Paintball Equipment
Forum Name: Upgrades and Customizing
Forum Description: Trick it out!
URL: http://www.tippmannsports.com/forum/wwf77a/forum_posts.asp?TID=187414
Printed Date: 12 June 2026 at 5:06am
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: carver one ups
Posted By: bgaris0503
Subject: carver one ups
Date Posted: 27 December 2010 at 2:18pm
| i did some reading and could really find any answers...i was interested in getting a carver one and iw as wondering if it was able to fit a regulator? thanks |
Replies:
Posted By: Mack
Date Posted: 27 December 2010 at 8:10pm
|
It's not a direct "bolt-on" upgrade, but there are several ways to do it with the addition of a few extra parts and a different hose.
------------- 
|
Posted By: bgaris0503
Date Posted: 28 December 2010 at 1:12am
| ok good to know thank you |
Posted By: Mack
Date Posted: 28 December 2010 at 7:44pm
I ran a vertical reg on on one my 98s a few years ago and used a piece like the one below to screw the reg into the valve. (I just removed the gas line and attached this piece to the valve.) You can't use the reg as a grip because it would place to much stress on the valve but it worked for my purposes. Not having a Carver to play with I would have to guess (based on pics) that the fit might be tight because the Carver trigger guard seems to be bigger than the one on the 98. Oh yeah, I ran macroline from the ASA to the reg. Edited Addition: Another problem is I don't know if the Carver uses a threaded valve like the older 98s or the new compression fit. If it is the compression fit, this obviously would not work. (I tried looking at the http://www.tippmann.com/pdfs/products/usarmy/Carver_One_Schematic_PartsList_4web_012610.pdf - schematic , but just wasn't sure.) You could still probably run an inline one. You might even be able to mount it on one of the rails using a scope ring, but I think any inline one would look tacky. -------------
|
Posted By: bgaris0503
Date Posted: 28 December 2010 at 9:51pm
| cool thanbks for the info its greatly appreciated! |