Gun Maintenace and Repair - Crossover Sticking?

Print Page | Close Window

Crossover Sticking?

Printed From: Tippmann Paintball
Category: Paintball Equipment
Forum Name: Gun Maintenace and Repair
Forum Description: Important info for keeping your marker in top shape
URL: http://www.tippmannsports.com/forum/wwf77a/forum_posts.asp?TID=191277
Printed Date: 03 September 2025 at 4:54pm
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com

Topic: Crossover Sticking?

Posted By: Avint
Subject: Crossover Sticking?
Date Posted: 24 June 2013 at 7:18pm

I have my Tippmann crossover and have installed the new trigger. I have found the gun to be sticking when in electronic mode and firing after fast triggers pulls and then continues with no trigger pulls. I usually have to flick or tap it again to stop, has been a huge issue in some speedball games as blowing paint rather quickly but more so because I seem to fire alot more then needed and getting bounces or people accusing me of ramping or running fully auto mode. I show them the issue and its fine but worried as I want to use this gun more in some leagues and team matches.

No problem in standard mode, works great and loving the gun, just worried about this issue.

Done so far:

Installed new trigger, with and without spring, currently using spring

Have cleaned the trigger and the parts around it

Re lubbed all pieces too,

With the grip off it appear to be the L shaped medal piece getting stuck on the magnet or circle spot. I apologize for the lack of technical description there, best way to describe it.

Any steps to fix this would be awesome, thanks.

Replies:

Posted By: TippmannEmployee1
Date Posted: 27 June 2013 at 12:53pm

If your trigger is running on. Then you do not have it adjusted correctly. Watch this video http://youtu.be/S5ypJVvP3G4" rel="nofollow - http://youtu.be/S5ypJVvP3G4 It will show you how to install & then adjust it. Let us know how it goes.

Posted By: Avint
Date Posted: 07 July 2013 at 7:24pm

That has fixed the running issue. But after fixing this and replacing the parts the gun will not save a change to the firing mode. I was in Blue, wanted to use 3 burst shot red. After following the manual and saving the settings (all showing it was done) the boot up does not show the program as saved. I reset to factory, replaced battery, same thing. Is this is a board issue?

Posted By: TippmannEmployee1
Date Posted: 05 August 2013 at 2:10pm

Give our service department a call if you are sure that you programmed it correctly. Call 800 533-4831. Thanks.