Leakage help
Printed From: Tippmann Paintball
Category: Tippmann Paintball
Forum Name: New Player Forum
Forum Description: New to the sport? Get Professional Advice Here!
URL: http://www.tippmannsports.com/forum/wwf77a/forum_posts.asp?TID=191556
Printed Date: 12 July 2025 at 7:45pm
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: Leakage help
Posted By: Noobster
Subject: Leakage help
Date Posted: 24 December 2013 at 11:34pm
|
I need a bit of leakage help on two guns:
XVR This one has a lot of variables and there may not be anything wrong at all. I shot it, and it did fire well. It did. However, it did, occasionally, where the velocity adjuster is, leak a bit of air. Just a small hiss for a second or two, barely any loss of air. My can I used is old, a nine-ounce Co2 can from my first Gryphon, and it might be the problem. It was very cold out, and my tank is not yet anti-siphoned or remote lined. Any ideas? TiPX Ok, this one is most likely broken. Upon firing, the gas started flooding everywhere. I tried it multiple times, but to no avail. I also noticed the cartridges had only a teeny hole, not sure if normal or not. They were not Tippmann, they were Crossman, but seemed to fit fine. Suggestions? Thank you!
|
Replies:
Posted By: Noobster
Date Posted: 25 December 2013 at 11:34am
|
Follow Up:
This morning, my Crossover wouldn't fire at all. Sending both back to get replacements.
|
Posted By: Specturesix
Date Posted: 29 April 2015 at 12:39pm
| try and replace your O-rings, might be damaged |
Posted By: Ceesman762
Date Posted: 29 April 2015 at 1:19pm
Welcome to the forum. This thread has been dead for some time, since 2013. ------------- Innocence proves nothing FUAC!!!!! |
Specturesix wrote: