ok i have a couple of questions!
Printed From: Tippmann Paintball
Category: Paintball Equipment
Forum Name: Gun Maintenace and Repair
Forum Description: Important info for keeping your marker in top shape
URL: http://www.tippmannsports.com/forum/wwf77a/forum_posts.asp?TID=191809
Printed Date: 22 December 2024 at 8:57pm
Software Version: Web Wiz Forums 12.04 - http://www.webwizforums.com
Topic: ok i have a couple of questions!
Posted By: monstereaters
Subject: ok i have a couple of questions!
Date Posted: 22 April 2014 at 12:22pm
|
ok my first question is the difference between the A-015 and any other o-ring? my second question is what is an Adapter UFA? I have a venturi bolt, do i need to upgrade that or is it a fairly good bolt? ------------- LOCK AND LOAD!!!!! WE ARE GOING HUNTING!!!! |
Replies:
Posted By: monstereaters
Date Posted: 22 April 2014 at 12:51pm
|
And none of these are related to one specific gun! ------------- LOCK AND LOAD!!!!! WE ARE GOING HUNTING!!!! |
Posted By: Ceesman762
Date Posted: 22 April 2014 at 1:40pm
|
Which marker do you plan to upgrade? ------------- Innocence proves nothing FUAC!!!!! |
Posted By: monstereaters
Date Posted: 22 April 2014 at 2:03pm
|
It's a psycho ballistics silver bullet ... ------------- LOCK AND LOAD!!!!! WE ARE GOING HUNTING!!!! |
Posted By: Ceesman762
Date Posted: 22 April 2014 at 3:03pm
Some one may be able to help you with that marker, Tallen, mack or Detrivini or go here. http://www.techpb.com/forum/forum/936-gun-techroom/" rel="nofollow - http://www.techpb.com/forum/forum/936-gun-techroom/ ------------- Innocence proves nothing FUAC!!!!! |
monstereaters wrote:Posted By: Lightningbolt
Date Posted: 22 April 2014 at 5:59pm
|
The aluminum bolts are very heavy if that's what you have. If you switch to Delrin you may be able to lower you operating psi. Los of benefits to that for a higher pressure gun.I found that lowering hammer weight allowed me to lower the psi a lot. |
Posted By: monstereaters
Date Posted: 22 April 2014 at 6:06pm
|
Thanks lightningbolt :-) ------------- LOCK AND LOAD!!!!! WE ARE GOING HUNTING!!!! |
Posted By: Lightningbolt
Date Posted: 22 April 2014 at 10:30pm
| Anytime. The hammers for those guns should be cheap so if you're interested the modi performed I had not seen before. I tappered the back of the hammer and gun drilled it as well. It looks like a ported tadpole. With that and a delrin bolt you'll be cycling at very low psi. I think mine dry cycled at around 140 psi with a polished stock aluminum bolt. You'll need a valve spring kit to adjust dwell time. I'm not familiar with electro spyders but if yours is maybe the dwell is adjustable there. Not sure if that is even possible with the design of the spyder. I think I had to remove a venturi from the valve or something too. If you get into the project this much I can tear the gun down and see what I did. |
Posted By: Lightningbolt
Date Posted: 23 April 2014 at 11:05pm
|
In addition, all of this stuff I did it turned out that it chronoed at the correct speed on the first check (which was hilarious in itself) so it cycled paint at that low psi too. And I removed the venturi from the bolt and drilled out the valve to allow for greater air flow. |