98's low velocity

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic


   I bought a mess of old 98's , settin in a trailer for 10/12 years , cleaned them up , oiled them up , new ball detents , they ALL air up good and DON'T leak air , i've got the fps up on about a third of them , i've taken 2 markers to work on , on these 2 , I had 2 new springs ( length 4 3/8 ) , swapped springs out , not much diff maybe 5 fps , so I figgered quit being cheep & put orings in it ; new hammer & bolt orings ,still very little diff , the first shot will hit high 260's , then they fall to the 240's i'm using a crossfire reg with 750 output , the paint is loose , but a had a Freak on it and all it did was make it consistent 240's  , not really sure where to go at this point , thanks for any help
Hank

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
MANIAC MECHANIC Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 27 September 2005 Location: United States Status: Offline Points: 16	Post Options Post Reply Quote MANIAC MECHANIC Report Post Thanks(0) Quote Reply Topic: 98's low velocity Posted: 21 June 2015 at 7:48pm
	I bought a mess of old 98's , settin in a trailer for 10/12 years , cleaned them up , oiled them up , new ball detents , they ALL air up good and DON'T leak air , i've got the fps up on about a third of them , i've taken 2 markers to work on , on these 2 , I had 2 new springs ( length 4 3/8 ) , swapped springs out , not much diff maybe 5 fps , so I figgered quit being cheep & put orings in it ; new hammer & bolt orings ,still very little diff , the first shot will hit high 260's , then they fall to the 240's i'm using a crossfire reg with 750 output , the paint is loose , but a had a Freak on it and all it did was make it consistent 240's , not really sure where to go at this point , thanks for any help Hank
	maniac mechanic Owner / Operator Preston County Paintball

tallen702 Members Profile Send Private Message Find Members Posts Add to Buddy List Moderator Group Hipster before Hipster was cool... Joined: 10 June 2002 Location: Under Your Bed Status: Offline Points: 11851	Post Options Post Reply Quote tallen702 Report Post Thanks(0) Quote Reply Posted: 21 June 2015 at 9:43pm
	I'd double check the power tubes to make sure there aren't any cracks in them. That's usually the culprit when there's a velocity issue that can't be solved by the traditional methods.
	<Removed overly wide sig. Tsk, you know better.>