ASA and E-Grip

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

I just got my new E-grip today and finished setting it to the settings I
want.  Anyways when i went to put my ASA adapter back into the
handle the bolt that goes through the ASA would not go.  If i
tightened it all the way eventually the grip would start to split at
the seams.  I think my problem is that the ASA is in the grip a
little bit crooked and that is what is causing the bolt to go in hard.

The only solution that I could conjur up was to possibly drill out the
hole that goes through the ASA.  Or might this be a mistake.

Currently I have my remote going directly into the gun. But that isn't my preference. 

Any help will be greatly appreciated. Thx.

Edited by Rudy - 14 July 2006 at 11:49pm

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Rudy Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 25 July 2005 Location: United States Status: Offline Points: 55	Post Options Post Reply Quote Rudy Report Post Thanks(0) Quote Reply Topic: ASA and E-Grip Posted: 14 July 2006 at 11:49pm
	I just got my new E-grip today and finished setting it to the settings I want. Anyways when i went to put my ASA adapter back into the handle the bolt that goes through the ASA would not go. If i tightened it all the way eventually the grip would start to split at the seams. I think my problem is that the ASA is in the grip a little bit crooked and that is what is causing the bolt to go in hard. The only solution that I could conjur up was to possibly drill out the hole that goes through the ASA. Or might this be a mistake. Currently I have my remote going directly into the gun. But that isn't my preference. Any help will be greatly appreciated. Thx. Edited by Rudy - 14 July 2006 at 11:49pm

cus98tom Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 12 July 2005 Status: Offline Points: 491	Post Options Post Reply Quote cus98tom Report Post Thanks(0) Quote Reply Posted: 15 July 2006 at 8:05am
	Loosen the three philips head screws and then insert the ASA, this may help with the alignment. You may be over tightening it , try holding the short end of the wrench and tighten , this will limit the amount of torque yoe can apply.

Rudy Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 25 July 2005 Location: United States Status: Offline Points: 55	Post Options Post Reply Quote Rudy Report Post Thanks(0) Quote Reply Posted: 15 July 2006 at 9:40am
	Hey thanks, it worked.

cus98tom Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 12 July 2005 Status: Offline Points: 491	Post Options Post Reply Quote cus98tom Report Post Thanks(0) Quote Reply Posted: 15 July 2006 at 9:25pm
	No problem, Glad I could help.