|
pro lite |
Post Reply 
|
| Author | |
killa k 
Member 
Joined: 11 April 2005 Status: Offline Points: 4 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: pro litePosted: 11 April 2005 at 6:57pm |
|
what is the blue rubber part in the back end of the pro lite? What does it do? Dose the gun need it to work? thanks |
|
 |
|
|
killa k
Member
Joined: 11 April 2005 Status: Offline Points: 4 |
Post Options
Thanks(0)
Quote Reply
Posted: 11 April 2005 at 8:34pm |
|
also there are 2 springs in the trigger one is conected to the trigger and the others broke, but at paintballgear.com they inky have the spring trigger |
|
|
|
|
SR_Crewchief
Platinum Member 
Joined: 12 June 2002 Location: United States Status: Offline Points: 2663 |
Post Options
Thanks(0)
Quote Reply
Posted: 11 April 2005 at 9:47pm |
|
If the rubber part your asking about is round less the a 1/4 inch thick with a hole in the middle, then it goes between the hammer and the endcap with the drive pin and spring going through it. It's called a buffer and for the long term life of your gun, yes it is needed.
There should only be one spring on your trigger. It goes from the hook on the back of the trigger to the nearest pin lower than the mid point of the trigger. The only other spring that should be in the grip/lower reciever is for the sear (the semi flat bar). The sear pivots on the top most pin with the spring forward and attached to the pin that is roughly between the sear pivot and the trigger spring anchor pin. |
|
|
|
|
killa k
Member
Joined: 11 April 2005 Status: Offline Points: 4 |
Post Options
Thanks(0)
Quote Reply
Posted: 12 April 2005 at 5:34pm |
|
thanks
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options