A5 Flatline 2mm=A BIG FAT MISS!

I suppose you could try to cut the threads somehow, but if you don't want to do that, I would just learn to deal with it. 1-2 feet isn't bad anyways, as at long range, most paintballs will end up going that way anyways.

JaguarChris wrote: Just wondering if anyone else has had this problem: My Flatline barrel leans to the left approximately 2mm, which inevitably throws my shots off by about 1-2 feet. I've refitted the barrel numerous times without resolve.  Since I bought the barrel earlier this spring, I'm worried that the warranty will be up. Does anybody happen to know whether they offer a full 1 year factory defect warranty on the barrel, or whether it is only covered for the measly 90 days? Thanks guys! Chris <!-- var SymRealOnLoad; var SymReal; Sym() { window.open = SymWinOpen; if(SymReal != null)      SymReal(); } SymOnLoad() { if(SymRealOnLoad != null)      SymRealOnLoad(); window.open = SymRealWinOpen; SymReal = window.; window. = Sym; } SymRealOnLoad = window.onload; window.onload = SymOnLoad; //-->

From what youve described, I dont think the barrel is in any way defective and you also, stated that the every shot shoots to the left...try holding your marker straight up & down as it should be and as required when using the Flatline on either the 98c and the A5.

Are you sure its a defective barrel, and not just in the adaptor crooked?  Sometimes they're off by just a little bit in the actual adaptor, and all you need to to is re-align them

jj

with the shroud off...

sight down the barrel. hold if by the adapter and look on top of the screw hole on the adapter. when looking at the barrel this way, you are looking at it as if its on the A-5. the screw hole should be on top. does the barrel sight strait this way? or is it sighting to the left or right?

look on the barrel (no shroud) and look for a center mark. its like a perfectly strair scratch on the barrl, near the adapter. this should be inline with the screw hole on the adapter also.

when the center mark is inline with the top screw hole, that means the barrel is seated correctly in the adapter.

if thats whats wrong you can straighten it. stick a small enough allen down, into that top screw hole ad unloosen it, make the barrel center mark line up, or sight it strait with the screw hole since that what you are using to line it up in the A-5 with when the shroud is back on. tighten the screw in teh adapter to the barrel is tight.

if that wasn't what was wrong, then i think you should just be able to turn the barrel to the right, while on the A-5 until its strait. you don't have to screw the A-5 all the way in. you just have to line the top shroud screw hole up with the center of the front sight.

remember, make sure the barrel is inline with the screw hold on the top of the adapter, and make sure the top screw is in line with the front sight. good luck

You could just call Tippmann CS and find out for sure wether or not they'll repace it.  I've had them repace out of warranty parts for free before, so just call up and ask nicely.  Or if you would rather agonize over your problems than fix them, there is plenty of abuse to be had here.