Gauges

would i be able to add a Gauge to my tippmann and if so where would i mount it??

What are you talking about Carl? A gauge and reg are completly different. Yes, you can attach a gauge there should be a hole in your bottomline asa than you can make by screwing out one of the "hex nuts". If you are useing c02, make sure you get a 0-1200 Gauge, 0-850's can easily break while useing C02. I use on on my gauge and I'lll show you a pic of it *NOTE* I am useing the Shocktech drop + ASA.. I'm not actually sure if the stock ASA has the whole that I used....it should though. Here is the pic I promised. And make sure you put teflon tape on the gauges threading when you screw it into the ASA




Edited by Mr. Blonde - 09 October 2006 at 2:54am

Mr. Yum Yums wrote: Dont u 4get 2 put dat darn solenoid, in dat gauge buddy!

Toe tally

Guages are only helpful if they are installed after the second satge regulator (HPR: stabilizer for example) because it will tell you what pressure the gun is operating on. A guage on the ASA is only telling you what the output of the tank is, which is pretty much useless.

Generally, guages are not used in a C02 environment. 

C02 is the same pressure until it is almost out.