|
ball chamber milling |
Post Reply 
|
| Author | |
pballraper 
Member 
Joined: 06 August 2004 Location: United States Status: Offline Points: 32 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: ball chamber millingPosted: 15 August 2004 at 12:13pm |
|
what do you guys think about milling the ball chamber in the link below? do u think that it will waste gas in any way or would the gas that is venting be excess gas? just tell me what you think. |
|
 |
|
|
pballa j.r.
Gold Member 
Strike1~Language. 12/04 Joined: 27 April 2004 Location: United States Status: Offline Points: 1593 |
Post Options
Thanks(0)
Quote Reply
Posted: 15 August 2004 at 12:18pm |
|
no you wont waste/loose anything
|
|
|
|
|
|
|
Kevin Z
Gold Member
Joined: 06 August 2003 Location: United States Status: Offline Points: 1168 |
Post Options
Thanks(0)
Quote Reply
Posted: 15 August 2004 at 12:57pm |
|
As the ball is fired, the action is blown back. The bolt comes out of the barrel while there is still residual pressure from firing the ball. this pressure has no where to go but back up the feed tube blowing the balls back into the hopper. I have milled my primary M98 custom Recently I bought an M98, just to mill the gills. Yes it helps keep the balls going in the right direction, no it does not waste gas. |
|
|
United States Marine Corps.... When it absolutely, positively, has to be destroyed overnight!
Just say NO to junk mods |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options