![]() |
A5 E-Grip out of control........ |
Post Reply ![]() |
Author | ||||
2SSB ![]() Member ![]() ![]() Joined: 15 August 2007 Location: South Africa Status: Offline Points: 6 |
![]() ![]() ![]() ![]() ![]() Posted: 15 August 2007 at 6:30am |
|||
Edited by 2SSB - 15 August 2007 at 6:31am |
||||
![]() |
||||
RoboCop ![]() Moderator Group ![]() ![]() Aw man, my butt is rusted... Joined: 06 November 2004 Location: United States Status: Offline Points: 5196 |
![]() ![]() ![]() ![]() ![]() |
|||
Low air. Fill up the tank. When it is low on air, the hammer doesn't have enough pressure to be pushed all the way back to be cocked again.
|
||||
![]() |
||||
Roweazie ![]() Member ![]() ![]() strike 2, Inapropiate Picture 10-5 Joined: 16 October 2006 Location: United States Status: Offline Points: 402 |
![]() ![]() ![]() ![]() ![]() |
|||
first remove the silver pin on your trigger, and see if it would resolve it.
|
||||
![]() |
||||
![]() |
||||
2SSB ![]() Member ![]() ![]() Joined: 15 August 2007 Location: South Africa Status: Offline Points: 6 |
![]() ![]() ![]() ![]() ![]() |
|||
The tanks is fill when I put it on.....
Edited by 2SSB - 16 August 2007 at 5:36am |
||||
![]() |
||||
2SSB ![]() Member ![]() ![]() Joined: 15 August 2007 Location: South Africa Status: Offline Points: 6 |
![]() ![]() ![]() ![]() ![]() |
|||
Roweazie what silver pin on the trigger? The armature pin that goes on to the solenoid.......
![]() Edited by 2SSB - 16 August 2007 at 5:38am |
||||
![]() |
||||
Roweazie ![]() Member ![]() ![]() strike 2, Inapropiate Picture 10-5 Joined: 16 October 2006 Location: United States Status: Offline Points: 402 |
![]() ![]() ![]() ![]() ![]() |
|||
Notice the metal peice on the back of the trigger, remove that and try it out.
What exactly "all ape on me", anyway?
Edited by Roweazie - 16 August 2007 at 7:52am |
||||
![]() |
||||
![]() |
||||
jesseat956 ![]() Member ![]() ![]() Guested - Language Joined: 09 August 2007 Location: United States Status: Offline Points: 191 |
![]() ![]() ![]() ![]() ![]() |
|||
if u remove that the trigger still works????
|
||||
![]() |
||||
Jason Doering ![]() Member ![]() Guested - Language Joined: 29 July 2007 Location: United States Status: Offline Points: 106 |
![]() ![]() ![]() ![]() ![]() |
|||
|
||||
![]() |
||||
Roweazie ![]() Member ![]() ![]() strike 2, Inapropiate Picture 10-5 Joined: 16 October 2006 Location: United States Status: Offline Points: 402 |
![]() ![]() ![]() ![]() ![]() |
|||
BTW, the pin was talking about is called: Slider pin & w/ slider spring.
|
||||
![]() |
||||
![]() |
||||
mod98commando ![]() Platinum Member ![]() ![]() Joined: 10 June 2002 Location: United States Status: Offline Points: 4432 |
![]() ![]() ![]() ![]() ![]() |
|||
The slide that he suggested you remove is used in a mechanical trigger setup to push the edge of the sear up which will cause the back end to go down and release the rear bolt. That is what normally fires the gun. When you get an egrip, the solenoid pushes the armature pin into the bottom of the sear where the trigger slide usually does. That's why you don't need it anymore when you go electronic. And, as mentioned, the slide usually interferes with the operation of the egrip so it's best to remove it while you have the egrip installed. If it is still in there, remove it and see if the problem persists.
EDIT: Jason Doering, I don't know what possesses you to write in such a light color but it's a horrible idea, don't do that. Edited by mod98commando - 20 August 2007 at 11:07pm |
||||
oreomann33: Everybody invades Poland
Rofl_Mao: And everyone eats turkey Me: But only if they're hungary Mack: Yeah but hungary people go russian through their food and end up with greece on everyth |
||||
![]() |
||||
2SSB ![]() Member ![]() ![]() Joined: 15 August 2007 Location: South Africa Status: Offline Points: 6 |
![]() ![]() ![]() ![]() ![]() |
|||
Thx to Roweazie and to mod98commando for all the help. Roweazie "going ape on me" just another word for going out of control........ Meaning when I pull the trigger and then release it again it still carries on firing, it does not stop even after I have released the Trigger. the only way to stop it is to wait for the gas to finish or take of the gas...... |
||||
![]() |
||||
abacus420 ![]() Member ![]() ![]() Joined: 14 July 2007 Location: United States Status: Offline Points: 1 |
![]() ![]() ![]() ![]() ![]() |
|||
Thx man i was flipping out last weekend , i was playing and i would use a tank of air every game, my A-5 was just running on and on. air was free all day luckly but i still couldnt figure out why this would just run on. Got the double trigger a few days b4 and noone said anything about removing that pin **edited** thx you made my weekend MY SETUP TIPPMANN A-5 TIPPMANN FLATLINE BARREL TIPPMANN 6 POS. ADJ. Stock TIPPMANN A-5 DOUBLE TRIGGER |
||||
![]() |
||||
Jason Doering ![]() Member ![]() Guested - Language Joined: 29 July 2007 Location: United States Status: Offline Points: 106 |
![]() ![]() ![]() ![]() ![]() |
|||
ok sorry bout the white text...every time i sign on my text likes to switch to white so i have to switch it to black
|
||||
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |