|
Cylone Banjo Screws Help |
Post Reply 
|
| Author | |
nightmarez 
Member 
Joined: 15 July 2008 Status: Offline Points: 11 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Cylone Banjo Screws HelpPosted: 05 December 2008 at 10:23am |
|
So I'm taking about the cyclone for the x7 and need help.
The banjo fitting that is connected to the marker and cyclone; does the screws have to be aligned with the air hole in order for the cylone to work? If so please tell me a way to aligned it b/c its kind of difficult. |
|
 |
|
|
TinMan
Gold Member 
Joined: 10 October 2007 Status: Offline Points: 1003 |
Post Options
Thanks(0)
Quote Reply
Posted: 05 December 2008 at 5:23pm |
|
No. The screw allows air to pass through no matter the slot position, |
|
|
|
|
The Guy
Platinum Member 
Soup Can Guy Joined: 18 March 2004 Status: Offline Points: 6666 |
Post Options
Thanks(0)
Quote Reply
Posted: 06 December 2008 at 1:17am |
|
you would never get a good seal and get them aligned. It would be really difficult to tap that way.
It would also eliminate the point of the banjo fitting |
|
|
|
|
Enos Shenk
Platinum Member
~-o@ Joined: 10 June 2002 Location: A comfy chair Status: Offline Points: 14109 |
Post Options
Thanks(0)
Quote Reply
Posted: 06 December 2008 at 2:14am |
|
The trick to those screws is only tighten them so much. If you keep turning the screwdriver and see the bottom o-ring deforming out of the fitting, its too tight.
|
|
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options