|
act question |
Post Reply 
|
| Author | |
mymaro 
Member 
Joined: 20 May 2004 Status: Offline Points: 38 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: act questionPosted: 15 March 2009 at 5:56pm |
|
so i recently picked up 3 98s from a pawnshop and one was an act so i switched all my mods over from my old gun. i shot it for the first time today and like it better then my old 98 but i noticed that if or when a ball does not fall into chamber it shoots full auto like when you run out of c02? what causes this. is it worth upgradeing to the cyclone i dont want to go electric because i like a lowprofile hopper and they make a 50 rnd hopper for the cyclone so i would get that?
|
|
|
98 custom
j&j pro 1 tippy expansion chamber rear velocity adj sealed cock and i also drive a 97 pontiac firebird |
|
 |
|
|
Evil Elvis
Moderator Group 
Crusher of Dreams Joined: 10 June 2002 Location: United States Status: Offline Points: 4250 |
Post Options
Thanks(0)
Quote Reply
Posted: 16 March 2009 at 12:49am |
|
the ACT keeps the front Bolt from slamming into paint and bursting it. So the Marker still cycles but the Bolt doesn't strike forth. I have mine on my Alpha Black (98 intrenals) with a Cyclone and it works well.
|
|
|
|
|
|
|
mymaro
Member
Joined: 20 May 2004 Status: Offline Points: 38 |
Post Options
Thanks(0)
Quote Reply
Posted: 16 March 2009 at 11:00pm |
|
yes i understand how that works and works flawlessly however when it is activated it goes into a full auto mode and wont stop until a ball falls into place?
|
|
|
98 custom
j&j pro 1 tippy expansion chamber rear velocity adj sealed cock and i also drive a 97 pontiac firebird |
|
|
|
|
Robby_of_PBH
Member
Joined: 03 March 2007 Location: United States Status: Offline Points: 282 |
Post Options
Thanks(0)
Quote Reply
Posted: 24 March 2009 at 9:16am |
|
Your gun shouldn't be doing that at all, the ACT isn't supposed to do that. Maybe when a ball is getting stuck the hammer isn't hitting the pin with the amount of intended force therefore the hammer is not blowing back enough to catch the sear which could be giving you the full auto effect much like when your low on CO2. That or you have problems with your sear or something.
Take your gun apart and make sure everything's in place and oiled correctly. Make sure the rear plastic plate isn't sideways or anything also, I know that's not great for the ACT, although I'm not sure it's possible to get that out of line unless you have a stock or something without the small extra notch of plastic that prohibits that.
|
|
|
|
|
GOMEZ15
Member
Joined: 29 March 2009 Location: New Mexico Status: Offline Points: 124 |
Post Options
Thanks(0)
Quote Reply
Posted: 02 April 2009 at 7:45pm |
|
sounds like a problem i had. my 98 (not act) didn't cock back all the way, i replaced the rear bolt o-ring. it worked fine. but u have act so it may be a different story
|
|
|
FORUM snowboarding
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options