Victor updates

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I've been messing with the Victor a bit.  It shoots surprisingly smooth.  
 Java volumizer,  high pressure Max Flo.  

Custom offset plate.  This was my solution to use standardized asa's.  I also switched the grip frame to
asa screws from the hard to find stock 5/32 to 6/32.  

Stock hammer, valve and bolt.  All modified to run very low pressure. Madman springs.  I'll have  conclusive numbers on operating pressure before winter.  

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Lightningbolt Members Profile Send Private Message Find Members Posts Add to Buddy List Platinum Member PHAT and PLAT Joined: 10 July 2002 Location: bumping up Status: Offline Points: 5055	Post Options Post Reply Quote Lightningbolt Report Post Thanks(0) Quote Reply Topic: Victor updates Posted: 08 November 2009 at 6:33pm
	I've been messing with the Victor a bit. It shoots surprisingly smooth. Java volumizer, high pressure Max Flo. Custom offset plate. This was my solution to use standardized asa's. I also switched the grip frame to asa screws from the hard to find stock 5/32 to 6/32. Stock hammer, valve and bolt. All modified to run very low pressure. Madman springs. I'll have conclusive numbers on operating pressure before winter.

merc Members Profile Send Private Message Find Members Posts Add to Buddy List Platinum Member American Scotchy Joined: 10 June 2002 Location: VA, USA Status: Offline Points: 7112	Post Options Post Reply Quote merc Report Post Thanks(0) Quote Reply Posted: 08 November 2009 at 9:25pm
	ball park what PSI are you running? did you open up the valve/body any?
	saving the world, one warship at a time.

Lightningbolt Members Profile Send Private Message Find Members Posts Add to Buddy List Platinum Member PHAT and PLAT Joined: 10 July 2002 Location: bumping up Status: Offline Points: 5055	Post Options Post Reply Quote Lightningbolt Report Post Thanks(0) Quote Reply Posted: 08 November 2009 at 10:25pm
	250-280 psi thru a Palmer and I'll be driving it lower. It chrono'd perfect right off the bench and I haven't touched any settings yet. The valve body is opened up. I'll probably get a delrin bolt, lower the operating pressure more and call it good. Too much work to go to any shorter of a bolt. It bites that the volumizer doesn't have a gauge port but I have a rig set up to test operating pressure on any gun. Just get the gun operating optimum over a chrono then check the psi after. Edited by Lightningbolt - 08 November 2009 at 10:28pm

The Guy Members Profile Send Private Message Find Members Posts Add to Buddy List Platinum Member Soup Can Guy Joined: 18 March 2004 Status: Offline Points: 6666	Post Options Post Reply Quote The Guy Report Post Thanks(0) Quote Reply Posted: 08 November 2009 at 11:40pm
	looks too green.
	My Site

Lightningbolt Members Profile Send Private Message Find Members Posts Add to Buddy List Platinum Member PHAT and PLAT Joined: 10 July 2002 Location: bumping up Status: Offline Points: 5055	Post Options Post Reply Quote Lightningbolt Report Post Thanks(0) Quote Reply Posted: 09 November 2009 at 7:44am
	Too green? It could end up with a pink feedneck =) Possible names for the gun are -Sanford and Son -Garage -JYD Edited by Lightningbolt - 09 November 2009 at 7:46am